Technics SL1200 Starts when I turn the power On. No need to press start!

ability to switch between 110 and 220 voltages. is it set at the wrong setting to power on? why did you need to replace inside wires? maybe something was touching inside and has blown the fuse. see legitimate repair shop.

p { margin-bottom: 0.21cm; }

HI,
After long years of use the electrolytic capacitors in the circuitry will get slightly change its value. If so it can affect the speed of the turntable. Its better to replace all the electrolytic capacitors in the turntable's electronic circuit board. It will not coast a lot for all the capacitors. Will only come around $3 or $4. .
OK

Most likley the phono cord, look here :-
http://cgi.ebay.co.uk/TECHNICS-PHONO-CORD-SL1200-SL1210-GENUINE-NEW-PART-/300439571601?cmd=ViewItem&pt=UK_AudioTVElectronics_HomeAudioHiFi_Turntables&hash=item45f3980c91

Cables are available here :-
http://cgi.ebay.co.uk/TECHNICS-PHONO-CORD-SL1200-SL1210-GENUINE-NEW-PART-/300439571601?cmd=ViewItem&pt=UK_AudioTVElectronics_HomeAudioHiFi_Turntables&hash=item45f3980c91

1, The regulator circuit has failed, usually transistors Q2, Q3 and zener diode D3.

OR

2, The drive I.C (I.C101 / AN6675) has failed, this can be natural failure but also can happen if the deck is turned on and started with the platter removed.

Free Technics SL1200 / SL1210 service manual available here :-
http://www.technicsdjuk.com/

http://stores.ebay.co.uk/methleykev

Most likley just the bulb itself. There is a guide on how to change the bulb on my website :-http://www.technicsdjuk.com/repair
The bulb is avaialble here :- http://cgi.ebay.co.uk/TECHNICS-TARGET-LAMP-SL1200-SL1210-GENUINE-NEW-PART-/300442165558?cmd=ViewItem&pt=UK_AudioTVElectronics_HomeAudioHiFi_Turntables&hash=item45f3bfa136

Usually just the knob, look here :-
http://cgi.ebay.co.uk/TECHNICS-POWER-KNOB-SL1200-SL1210-MK2-GENUINE-NEW-PART-/300442767389?cmd=ViewItem&pt=UK_AudioTVElectronics_HomeAudioHiFi_Turntables&hash=item45f3c8d01d

this one happend to me!! try taking the plastic cover off, under the platter and removing the screws that hold it on if that cures it its because what you ll find is that the screws just catch the underneath of the platter as it rotates. happy mixing