your machine is draining too slowly. When it initiates a drain cycle, the water level switch is sensing the water level is still too high after 60 seconds so the
computer stops and generates this fault code.
Here are the things to check;
* Check the drain hose and make sure it is not plugged or inked.
* Check Wire Harness connectors to the Drain Pump, Pressure Switch, and Central Control Unit (CCU)
* Check/Clean Drain Pump Filter of foreign objects
* Check for Drain Pump Failure
* Check the Inlet Valve for proper shut off
* Check the Pressure switch for proper operation
Originally there was the c9 error brushs were down to 1 cm these have been changed / error code was erased and then when it came to the spin cycle the pump continued to try to pump and but no spin the result was a c9 error again. Any tips
Error 10
No water intake on start-up.
Error code 10
No water intake on start-up
×