How many feet does HM3855L Model cover?

When going to buy a humidifier always check these points:
Technology used: Ultrasonic is good and inexpensive
Performance: The area it covers
Features: Does it offer both cool mist or hot mist
Design: compact and sleek design
customer support: The process of servicing and maintenance etc.
Read these top humidifier reviews to get the best
GroomNStyle Top 5 Best Humidifiers 2015

This link should open the manual for you. I covers both the frog (the model you have) as well as many others. http://cache.air-n-water.com/manuals/crane-ee-3191.pdf

if this is the bypass model there is a screw at the bottom of the cover that needs to be loosened. then the cover will flip up to expose the tray that holds the pad. take the tray out and squeeze the tabs on the black filler port to remove it. once the tray is out the top distribution tray can be removed by pulling the lower part off the tabs on the distribution tray. once they are apart remove old pad and wash both parts very well. You may need to scrub off the calcium build up or soak it in CLR to loosen scale. Once you have done this put the new pad in and clip the black filler port back on and test the humidifier.

I think you're on the rate track. If it's ten years old the blade and.or the shaft may be worn out. Turn off the water line feeding the humidifier.Turn off the electricity to the unit. Drain the tank, open he tank cover and try spinning the blades with your hand. That way you can tell and see what its rubbing against and if it can be repaired. But, if it's 10 years old, parts may not still be available for that specific model.

Good luck. Hope that helps.

Many of the newer Honeywell models have a battery compartment that can be accessed without removing the thermostat.
Look for a small tab at one of the top corners of the thermostat. If this is not the case try pulling directly away from the wall at the bottom, then tilt up.

Please call the Venta Customer service team.
1-888-333-8218

If you have proof of purchase the part ( cap) is covered under warranty. If you do not it will cost $13

Peice of cake: You run the white to sail switch the to common 2. Yrun thr re to humistat switch then to the white on the control board or conact us www.airenergyexperts.net

Clean it and dry it thoughly. Apply a small amount of 100 % silcone caulking with you finger. Seal it on both sides. Allow it to dry thoughly before it gets wet or it will leak.

If you email me at [email protected], I can send you a pdf of the manual for this product. I had the same model and was able to remove the fan cover by slightly twisting it and pulling up -- was able to clean the unit very well once I removed the cover! good luck...