SOURCE: servicing
There are a few ways to do this:
1). You can go through the Epson LFP Remote panel and select "Power Cleaning".
2). You can also find it through the print driver's utility tab.
3). If you hold down the "Pause" button, the machine will do a "Simple Cleaning". After the third time doing this, the machine will ask you to do a "Power Cleaning.
SOURCE: epson 4800 pro
Make sure that the "Encoder Strip" is clean and in the channel for the sensor located on the back side of the printhead carriage.
SOURCE: Turn the printer on and I get this message:
try this turn off the printer
then...
hold the power button and the pause button together, it enters factory rest mode
SOURCE: I am Eric, I have
SIMPLY CLEAN CLEAR RIBBON SENSOR BY PASSING CAR PRINT AND SEE IF THE SAME IS PLACED ON SITE WHERE IS THE SENSOR AND MAKE SURE THE RAIL CAR THAT IS NOT WITH DIRT runs ACCUMULATED THE CATCHING THE CAR I THINK THE NAME OF It ENCODER RIBBON
109 views
Usually answered in minutes!
×