Model#B9 5648(on base).Model#5643 Activator Series#549(on razor).Charger-Good LED on.Razor Ops-Good.Cleaning Ops-No.Fluid level(new cartridge)-no LED.Disassembled Base-visual OK.Need schematic of Base PCbds & wiring.Pump motor test-OK(by itself).New Base not option.($).All suggestions welcome. Thank You.
SOURCE: cleaning base
I have been shaving with electric razors for 48 years, and the Braun 8595 is by far the best one yet.
I have had the problem of the refusal of the cleaning station to recognize the level of fluid in the cartridge, three times over the last couple of years. It seems to relate to a build up of shavings in the unit. To get it working again I inverted the unit, and carefully flushed water via a small tube, back through the 1cm diameter hole in the underside of the open base. Of course, the unit must then be thoroughly dried before use, or the sparks may fly. Does anyone know how to dismantle the unit for a safer and more thorough clean?
SOURCE: I have a Braun 760 razor. The two electric
Useaa good emery paper to clean the surface of the contact, use a good contact oil to rub off the rust or dirt in the section. now repeat till it shine, do the same to the other end , Now since there is alwyas some moisture present the pins must be cleaned out after very use.
SOURCE: Braun 8585 shaver, charges fine,
The problem is the base, not the shaver. Most likely, the circuit board inside the base has gotten wet and is damaged. If this is the case, it will need to be replaced. You will find a replacement at shaveroutlet.com. See link below
http://shaveroutlet.com/shaver-replacement-parts/braun-8000-series-360-complete-clean-charge-base-p-116.html
5,345 views
Usually answered in minutes!
×