Trying to find a threading diagram for a Juki 1541
SOURCE: THREADING FOR JUKI MO 357
Put new needles in it.
Following the colors, thread the upper looper first, then the lower looper. Next thread the needles. Always thread in this order.
SOURCE: Need instructions for threading Juki MO 3314
Open the font of the serger and the instructions will be printed on the serger or on the door.
Raise the presser foot and set the tensions to zero when threading.
Turn the hand wheel so the upper looper (curved one) is at it's highest point and thread it first, and then the lower looper.
With some sergers you must thread in a certain sequence. This should be indicated in the instructions on the serger.
Set the tensions back to normal ( 4 - 6), lower the presser foot and run a length of stitching to see if the threads are knitted together as they should before you start serging your project.
SOURCE: Need threading instructions for JUKI
I also have a Juki DNU-1541S and I'v had nothing but problems. My bobbin will not feed out thread. The Pressure foot needs a wrench to lift it, the knee pad will not work due to the pressure foot being so stiff. YES, I've turned the knob at the top so much it's near comming off !!
The so-called "Instructional Manual" appears to be a "UNITED NATIONS" resolution in all languages. The English portions is barely enough to fit 1/4 page. A Manual ?? A JOKE is better.
Tweezers!! The ones with the angled tips.
585 views
Usually answered in minutes!
×