2400w error light - Konica Minolta magicolor 2400 Laser Printer

IT is 16year old today, and there are no spare parts, for it.
cept used on ebay.
the blinking lights in the manual mean, toner cartridge dead or fake one installed. on page 11.
if got it to work there are no windows 10 drivers, now. XP yes.

see that page 11 states on errors.
https://www.manualslib.com/manual/90066/Konica-Minolta-Magicolor-2400w.html?page=11#manual


the service manual is here,

https://www.manualslib.com/manual/805991/Konica-Minolta-Magicolor-2400w.html


RTM?

Hi
Usually these machines give you an error code on the control screen. You do not mention one but the webpage here:
Error Codes Konica Minolta Magicolor 2400W
gives most of the error codes for your model.
and also by changing the drop down menus along the top of the page you can view other errors for your machine and for other models and makes. You can also use the link to get a Service Manual for your machine.
Hope this is helpful, if so would you please register that with Fixya
Cheers

gggg

The possible reason for error is the printer does notread chip on the cartridges.
The reader for chips locate inside the printer bottom ofcartridges.
Take out all cartridges and you see reader it is a small blackplastic which come three contact plates.
Just clean it with compressed air and take out if some contactplate is sedentary.

GO and get 4 Konicminolta image units one for each color and replace them do not use third party. NEVER ever use a vacuum cleaner the static electricity can cause sensors to go bad !!!!!!!!!!!! might have destroyed the chips on the image units SO recommend get all new hopefully you did not destroy the control board with static electricity

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Hi

Try to open the blue cover and close it. Then press a few times the "rotate toner" button. After that powerswitch off and on, should run.
If it´s don´t worked, make sure you have every transport secure away from the cartridges.
The contact`s should be clean in Printer and on cartridges.
If still the same prob, start from first tip.
It´s worked by my 2400W feed new toner

hope it can fix your issue
Thanks for using Fixya

Try to open the blue cover and close it. Then press a few times the "rotate toner" button. After that powerswitch off and on, should run.
If it´s don´t worked, make sure you have every transport secure away from the cartridges.
The contact`s should be clean in Printer and on cartridges.
If still the same prob, start from first tip.
It´s worked by my 2400W feed new toner.

try lifting the drum assembly, at the back of the assembly there is a fuse. replace it. hope this helps

Start the Konica Minolta Status application and check the error, you should get more info there.

Reset your Toners and Imaging units for Bizhub and CF series.
http://www.chipreset.eu

Hi, you should check the position of paper sensor flag, called "actuator" (part number 4139 3505 02). On the picture - part 15. The "paper jam" error message means also - "toner cartidge missing", "paper out" or "photoconductor missing"