Speed Queen AWN542 - Speed Queen AWN432 Washer

Speed Queen AWN542 using the delicate cycle. Provides a brief
wash, 3 minute pause, quick agitation, then slow speed spin drain.

https://www.youtube.com/watch?v=VRyowST7tYo

It is likely to be one of the thermal fuses. You can check them with a multimeter for continuity.

https://www.google.com/search?q=Speed+Queen+ADE3SRGS173TW01+parts

Speed Queen wiring. Nothing specific to the model.

https://www.google.com/search?q=Speed+Queen+wiring+diagram

..

you have to pull out on the knob perhaps

this is all i can find..
Speed Queen Fault Codes ..

https://www.google.co.uk/webhp?sourceid=chrome-instant&ion=1&espv=2&ie=UTF-8#q=Speed+queen+error+code+Ed44+what+is+this

Not your desired results yet, but here may be a start:

Here is a generic online manual with some very good information: http://www.appliancerepair.net/speed-queen-washing-machine-repair.html SPEED QUEEN AUTOMATIC WASHER Parts Model awm373w Sears PartsDirect

Does it fill with water? When you try to start a load, does the timer run?

This is mentioned in the manual-the federal gov't has required manufacturers to set water levels lower to conserve water. You can fill it more by holding the load size level to reset until it has the amount you want.

Hello, you need to remove the motor and bracket flip it over remove the 3 torque screw from the pump and lift the pump off. Remember the belt only goes around one of the legs of the pump.. Good Luck and Please rate me it helps.. Thank You..

Normally there should be two screws at the bottom of the front panel.
The top cover usually lifts up by depressing the spring tabs located in the gap
between the top cover and the front panel to allow lifting of the front panel. These tabs
are located about two inches from each end and you can use a putty knife to push back.

Push the tabs back and lift the cover up, then remove
either two screws located inside the front panel or two screws on the outside at the
bottom of the front panel and lift the front panel slightly to disengage. Remember to
unplug unit before servicing. Hope this helps.

It could be your out of balance switch is getting tripped before you try it again put in the spin cyc and see if it spins and drains the water if it does a odd sized load could be causing the failure.