Whirlpool wfw94hex F3E2 - Whirlpool WFW94HEX Washer

Question moved from Cars and Trucks.

The Whirlpool washer F3E2 error code is a temperature sensor error. You can check the temperature sensor with an ohm meter to verify the sensor is bad. ... The correct ohm reading should be between 500-100K ohms, if not the sensor is bad and needs to be replaced.

Whirlpool Washer F3E2 Error Troubleshooting and Repair

Communication error UI to CCU basically the front control panel is not talking with the main control with one is the problem is a guessing game they are both mini computers

You can find the manual on FixYa here: http://www.fixya.com/support/p2593823-whirlpool_wfw94hex_washer/usermanual-7925617-pdf

Check the drain pump for obstructions.

F3E2 which is water temp sensor failure. Here is the part to order.

F3E2 error, Wash light flashes 3 times then 2.
Took off front lower cover, Found Manual!!!
Unscrewed filter and was so full of trash, clean and reassymbled and now works just like new. Simple fix no parts at all needed.

Everyone says to pull the front access panel off but my WFW94HEX machine also had no front panel. I took the back panel off and accessed the pump filter from the back side. All the rubber hoses were also coated with mildew and I cleaned them all out as well (the connection from the drain to the pump, the air vent, etc.). The smell is reduced but not gone. Not hard to do but I suspect it will not permanently fix the problem.

look behind thecontrol panal and find the wire diagrame,you may have to remove the back panal.un plug unit first.on the diagrame it has a place were it tell's you what f3e2 mean's.

I'd start with testing the oven sensor that if that is bad it wont be horrible because you'll have no problem replacing it yourself less than $100. That is where I'd start let me know if it works. Good Luck.

Diane