Saniflow sanisuite leaking from top - Saniflo SaniPlus-Round SaniPlus Macerator Toilet with Round Bowl

no power did not cause it to leak. check the wax ring on toilet closet flange

Your description sounds like plumbing from before bacteria was discovered. The output from a Saniflo macerator should be sent to a foul drain or cesspit and not a rainwater drain.

Some authorities allow local rainwater runoff into foul drains but this situation is gradually being designed out.

Could be your Saniflo installation didn't meet building regulations when it was installed. The fact it has been working fine for 2 years doesn't count for anything if it doesn't.

Shut off water supply and check where the leak is. Loosen the joint , reconnect it securely and reclamp. Before reclamping spray Stop Leak around the joint. Slowly open water supply. Goodluck.

Here is a nice link for your saniflow maintenance.
http://www.plumbteamltd.co.uk/sanifloguide.html
This will definately help.

Here is a nice link for your saniflow maintenance.
http://www.plumbteamltd.co.uk/sanifloguide.html
This will definately help.

find water pressure regulator. it will have a bolt coming out of the top with a nut at the base of it.loosen nut. while toilet is being flushed, adjust bolt till noise stops. turn bolt clockwise to adjust.

could be a part blockage alowing water to filter back never put paper or towles in it

I have a question, I have a saniplus no problems hooking it up filled the tank and then flushed it..On the discharge end I had a small about of water puddling up at the pressed in rubber fitting. Every clamp was tight not sure what the reason is any ideas. I thought about silcone around the rubbber seal between the lid.

See if you can adjust the highth of the saniflow,to make it kick on sooner. goodluck.

Dean:

No solution yet.