Blurred screen and photo

If you are convinced you did not switch the camera to manual settings, and the blur stays, please contact the nearest Canon certified service centre close to you. But before check the settings on the camera and start putting it on automatic.

Hi,
It is known problem of ccd imager chip failure in DSC-T1 camera, ccd imager chip will be replace to get correct live view in camera mode to take fresh pictures.
Local camera repair shop will do this job because camera will take apart, let me know to provide you part number info if you are handy with electronics stuff repair and willing to replace ccd imager chip.
Hope this will help.
Thanks.

To remove the blur from photos, you need to be in a place where there is enough light to have a fast shutter speed. Using the camera indoors without the flash on will usually result in blurry photos.
Try using the flash.

Holding the camera with two hands or even better, on a tripod, will help too.
Happy shooting!

Turn of the high quality mode to low quality mode... pictures will be clearer.

u cna use the camera reset setting it can reset the original manufacturer setting back to camera

Make sure that you have short enough exposure. I have taken steady shots with 1/8s and with some support (wall, table or similar) even 1/2s. Normally slower than 1/30s makes pictures blurred.
When shooting, don't **** the camera, but squeeze the trigger - your shots will improve. Trust me.

When operating any digital camera, the camera tries to capture the best focus and exposure for that particular scene. By pressing the shutter button half-way down, the focus and exposure is being set. There will be a green circle on the upper left hand corner of the screen, then your camera is ready to take the picture. Slowly depress the shutter the rest of the way down to take the picture.

The problem is with the CCd ..... Kindly get it replaced ...

Blurness doesn't happens because of the number of the pixels in the cameras.
Is the picture on the computer screen blur/the cameras screen or the lens hole?

I suggest you to set the camera on Automatic station (red camera on the wheel) in day light,try to stay still see how blur the photos are when you are not playing with the parameters. it it's still blurry it could be the pulley block next to the -eyepiece. roll it until it's not blur.

goodluck

You MUST be perfectly still to get a good picture. Even the slightest move will blur the image.