Mc75a how to configuring new line after scanning barcode

We recommend you contact Motorola Solutions.

portal motorolasolutions com

Mark
Motorola Mobility Support

portal motorolasolutions com Contact Motorola Solutions Support

Press the #1 and #9 while turning on the device.

Download here at motorola:

http://www.motorola.com/Business/US-EN/Business+Product+and+Services/Mobile+Computers/Handheld+Computers/MC75A_US-EN#support_tab

You need adobe reader to read the content.

Good luck

using MetroSet2,select "Scanability Mode" under Misc section.New configuration manual with Honeywell logo doesn't come with this configuration barcode,only those old manual with Metrologic logo has it.

Bar Codes The MS7120 can be configured by scanning the bar codes located in the MetroSelect® Single-Line Configuration Guide. This manual is available for download at http://www.honeywellaidc.com/site.aspx/na/en/product_center/product_support/?category=5&product=297

Please let me know if you need further assistance

Kim Ganoe 800.933.2839 x251.

Check metroselect single line configuration guide page no. 2
1) Scan Enter/Exit configuration mode it gives 3 beeps
2)Scan recall defaults it gives single beep
3)Scan Enter /exit configuration mode it gives 3 beeps
Now scanner is set to default setting

Firstly, You must be reset scanner.
for reset,

to find programing manual.

if you don't have it.I can send to you.

1. scan start of configuration barcode
2. scan reset barcode
3. scan end of configuration barcode

best regards

Ufuk

I'm using the same Barcode reader, the Metrologic MS9535 VoyagerBT.

The brief humming noize is called a "Rasbery tone" in the manual. It means that the barcode reader is not configured to read that kind of barcode, a barcode Code if you will.

There are many types of barcodes so you have to go to the Metrologic Website and get the Barcode Configuration tool to configure your barcode reader to read the type of codes you will be using.

Alternatively there is a book with configuration barcodes you can scan to configure your barcode reader manually.

Prefix/Suffix Dialogs
The Prefix/Suffix Dialogs allows configuration of DataWedge options.
Two data entry fields are used to display and allow entry or editing of prefix and
suffix strings. The prefix string, if present, is transmitted before the data for any
barcode scanned. The suffix string, if present, is transmitted after the data for any
barcode scanned.
The following checkboxes are used to display and allow modification of various
DataWedge options:
Allow escapes in prefix/suffix (default = disabled)
Enabling this option allows escape sequences to be embedded in prefix and
suffix strings. Escape sequences allow non-textual data to be transmitted as
part of the prefix or suffix string. All escape sequences begin with the backslash “\”
character. The supported escape sequences are:
\b Backspace
\f Form feed
\n New line (line feed)
\r Carriage return