Won't print My CLP-300 won't print. i get a red light only. I have opened everything and cannot see any paper jams. I emptied the little place where the ink deposits accumulate.

Hi paulette,
if the light is red and TONER COLORS LED all LEDs off

• The machine is experiencing an error, such as jammed paper, open cover, empty paper, installed waste toner container, or full waste toner container.
• The machine is experiencing a service required error, such as LSU error, fuser error, or Contact your sales or service representative.

if the light is red and TONER COLORS LED each LED lights red.

• Each toner cartridge is totally exhausted. You can not print.
• Each toner cartridge is wrong.

There is a few reasons that cause the status light to turn red, paper jam, paper empty, toner cartridge empty, cover open and waste toner cartridge full. The PC Smart panel utility should give you an exact fault condition. Hope this helps.

hi

find link for red light flashing issue

https://support.hp.com/in-en/document/c05573971

A red Status light means 'paper jam'. A red light corresponding to one or more of the toner cartridges means empty cartridge. A flashing red light corresponding to one or more toner cartridges means low toner.

you clean your printer drum unit wast ink poder drum open and wast ink

download smarrt panel from samsung website,install on pc and run.have printer connected.will resolve issue.

You may need to empty the excess toner bottle, it's in the front, to the left side.

A paper jam has occurred. To solve the
problem, see “Clearing Paper Jams” on
page 6.3.
• The front or top cover is opened. Close the
front or top cover.
• There is no paper in the tray. Load paper
in the tray.
• The waste toner container is not
installed or full. Check the container.
• Your system has some problems. If this
problem occurs, contact your service
representative.

• Also i can indicate that the Toner Cartridges are empty and need replaced with Genuine Samsung Cartridges
  

Check your ink levels as the red light comes on if the cartridges are low or empty and it will not allow you to print?