Slight water damage- Sony Cybershot w-80 doesnt turn on

• After pressing the power button in capture mode, the lens would extend and a slight humming from what appeared to be the auto focus motor could be heard for about 5 seconds. When the motor stopped humming, the camera would beep and display E:61:00 in the LCD Screen.
• Camera would extend the lens but not be able to focus on anything past 8 inches or so.
• Zoom in and zoom out would not work.
• Playback mode and the Setup mode was not affected.

To solve this
Put the camera about a half inch from a hard surface.
Let the lense go out and hit the surface and retract a little bit. Let it go out all the way when it tries the next time.
If that doesnt fix it, try this:
Turn it on and let the lense go out fully
See where the lens comes out of the camera? The little round crack that surrounds it? Wiggle the lense a bit and blow in there a bit. (Be sure not to blow on the lense!)

Now turn it off/on again, and it should be fixed

See the following video, It may also help you

Your Rating As Four Thumbs which are given below to this solution will appreciate me
Thanks and Keep using Fixya