How to reset factory settings for onkyo tx-sv303pro without the remote

Hello Arthur, The reset will take all of the settings back to factory default. This includes network settings and speaker settings. Thanks, FJD

If memory is not full, manually tune in the station that you wish to save. Then press Memory on the receiver on the left of the bank of buttons above the tuning buttons (the light will blink 8 seconds). Then press one of the Classified Memory presets (Class A - Class F); these are below and go to the right of the tuning buttons. The station will be stored in the lowest free memory space in that class. If the memory is full, you will see a message to that effect. If you wish to clear the memory, press and hold Memory and Mute (just to the right of the memory button).

The manual for the TX-SV303PRO is available from Onkyo support here: http://www.eu.onkyo.com/en/products/tx-sv303pro-98673.html?tab=Support . The downloads are on the right hand side of the page. The direct link to the English version of the manual is here: http://www.eu.onkyo.com/downloads/2/6/5/3/7/Manual_TX-SV303PRO_En.pdf . The information about storing channels is on page 12-13 (13-14 of the PDF).

I hope this helps.

Cindy Wells

heres a user manual
Onkyo TX SV303PRO

Try pressing and holding DVD button and pressing power button. It should reset it to factory settings.

http://static.fixya.com/Manuals/O/Onkyo/TX_DS595_5_1_61851C3AAA3EA98913A226B1F1FDDAD1.pdf there is the manual for your unit

try reset. push and hold vcr1 and then press power button while unit is on this will reset back to factory default

Hello Katieandjona,

My first & second
guesses would be monitor & head-set modes...
(possibly Zone 2 activated)

ELSE...

To reset the AV receiver to its factory defaults, turn it on and, while holding down the [VCR/DVR] button, press the [ON/ STANDBY] button (see page 93).


Manual... page 5

http://www.intl.onkyo.com/downloads/manuals/pdf/tx-sr507_577_manual_e.pdf

Hope this helps

Hello, I am sorry for your issue. Please go to replacementremotes.com and search txsv525. They do sell a replacement. If you email me at [email protected] and I will send you a copy of the manual. Thank you. Onkyo USA

are you using HDMI cables or component. First I would try unplugging the composite and component video cables while the receiver is off. Plug them back in and turn it back on. If that does'nt work try setting the receiver to factory default and redo the settings. You can find how to reset to default in your user manual.

Channel level output can be adjusted in the menu if you have the remote. Set the rear channel level volume higher and the fronts lower if need be, and then turn up the volume. Enjoy!