Need a parts manual broken chute control cable

I take it that your chute has a handle that turns a gear to make your chute turn. My plastic gear holder broke off so I now turn the chute by hand to where I want it and hold it in place with a tie down then I spin it by hand when I want to go the other way and hook it on the other side of the blower. It's a pain that way but Being an old machine I can't get parts for it. To hook the tie down hooks I drilled small holes in the sides of the chute and onto the body of the blower. To keep the cables from freezing i pour a little bit of car anti freeze on the area it freezes. Don't put too much on.

Need to know what cable you are asking about. Is it the starting cord for pull starting the engine or one of the auger or drive control cables ??
Can you post a picture ??

look on youtube for your model

W10224328 Dispenser Door Spring

The chute door is the reason your ice bin is freezing up and also the chute door being open draws warm moist air inside your freezer compartment causing massive amounts of frost and keeps the compressor runing all the time between defrost. You really n eed to get the chute door fixed. What is the correct model number? For the model KSRX25FT dispenser parts click HERE The chute door spring may be broken but you will not know untill you open the dispenser housing. I'm here should you post the correct model number or have questions, Sea Breeze

Sounds like the chute door was not shutting properly and the ice was melting a bit and sticking together . Replace door and it may work fine

I believe in your case the ice maker part number WR30X10093 being electronic with the control board in the front is the problem. I think the control board behind the front cover of the ice maker may have corrosion and causing the ice maker to malfunction. You can try disconnecting the set of wires to the coil on the water control valve and see if the water stops or turn off the ice maker first and try disconnecting the coil wires later. It has to be the control board or the water control valve part number WR57X10032

It appears to come with the chute assembly part # 631 04254

Step 1: Move the carriage to the center manually if necessary If the carriage is stuck on the right or left side of the product, follow these steps to move the carriage to the center of the product.
Step 2: Check for a broken carriage chute
The carriage chute is the side wall of the carriage that holds a curved metal piece (the x-bias spring). A broken carriage chute might cause the carriage jam condition.
Step 3: Turn the product off and on again
Step 4: Clear any paper jam.
Step 5: Make sure that the control panel faceplate is correctly installed
Step 6: Plug the All-in-One directly into a wall outlet
Step 7: Perform a partial reset
Step 8: Print a self-test page

Step 9: Service the product. Now this model is outdated as per HP website.

This sounds like your ice may be melting and freezing around the chute. You may need to replace that rubber gasket on the chute. Otherwise, if you use a lot of crushed ice, that will build up badly on the chute and you can manually clean that off. I hope this helps you!

Look and see if the door for the ice chute is closing all the way. This model is bad about that door breaking. If it doesn't shut properly then warm air getting in will cause this condensation. Will also cause ice in bucket to melt and water can leak onto these parts. If it isn't obviously hanging open then shine a flash light from the inside down the chute and see if any light comes thru to the outside. Maytag has a chute door kit that you can find on appliancepartspros.com. Their part # is AP3140440. Let me know if this helps or we need to go further.