NVRAM CM 1017 - HP Color LaserJet CM1015 Printer

Hi there
Please find below a link to the HP site and the page from which you download the manuals
http://h20565.www2.hp.com/portal/site/hpsc/public/psi/manualsResults/?sp4ts.oid=1846080
These should have all the information you need.
Good luck

http://content.janome.com/userfiles/file/Inst%20Book%207318%20%28English%29.pdf See p. 22 You snap off whatever foot is currently on, and snap on the buttonhole foot, #J.

how much the coby tablet 1017

Why are you formating? If you have a Recovery Partition do a Full System Recovery.

Open the Printers Properties, settings, select your print preference.

I have a PDF file that they sent me in an email on the 47-1017. If you need it email me at [email protected]

50.21 error is a "cyan scanning error"
Manual says to replace the DC Controller.
Get a tech to check it out, and if you want to get the printer printing again, listen to him.

here's a link for a manual
http://www.sewingpartsonline.com/instruction-manual-janome-harmony-1017.aspx

try these links about bobbin winding
http://www.youtube.com/watch?v=f3-qsUpErmA

http://www.youtube.com/watch?v=SnlU9ywfVEs

http://www.youtube.com/watch?v=Xw1HgTEK0VI

If nothing else works, you may have to manually calibrate the dials inside the mirror box. This video link will show you how. http://youtu.be/R1DIko0a1MA
This may be necessary if the printer got bumped really hard.

This reset will change user and network settings Before performing this reset it would be advisable to print some information pages to retain any settings that you might want to restore.

Configuration Page
Press Setup (wrench button) then arrow over to Reports, press OK, then arrow over to Configuration report, press OK.

Menu Structure
Press Setup (wrench button) then arrow over to Reports, press OK, then arrow over to Menu Structure, press OK.

Network Report
Press Setup (wrench button) then arrow over to Reports, press OK, then arrow over to Network Report, press OK.

After printing these reports it will be safe to perform an NVRAM initialization to hard reset the product. Follow these steps.

NVRAM initialization
1. Turn the machine off.
2. Press and hold the right arrow and cancel (x button) while turning the machine on.
3. Release both buttons when Permanent storage init. is displayed.

Once finished resetting the machine will return to Ready.