I have a GE Spectra XL44 stove. Model # JGBP30BEA5WH. The front right burner will click, throw a spark and light after about 10 seconds. That is the only burner that works. The other 3 will light if I use a match. The strange thing is if I try to light the other 3 using the appropriate knob, the front right burner will click and spark. I cleaned up the burners good and used sand paper to lightly clean off the stop of the ignitor. Suggestions?

SOURCE: ge spectra xl44 stove

Most likely the oven ignitor is bad or weak.  You can look at it and see how it compares to the broil ignitor.  If you see a whitish color on the ignitor and if it doesn't fully glow then it needs to be replaced. 

SOURCE: ge spectra gas stove top not lighting

no gas flow sounds like a bad gas regulato on the stove. as for the 5 year old ge profile with ignitors not working, you need a part called a spark modual

SOURCE: stove top burner Spectra XL4

rear left back burner clicks to ignite but doesnt

SOURCE: GE Spectra JBP64BB front right large burner won't work anymore

how are you the GE Spectra JBP78 Electric... Problem: Subject: the proble is that i had a shortge of power and i have the ""lockdoor"" showing

SOURCE: ge spectra gas stove top not lighting

If your top burners are not lighting or will not work, it is possible that the burners have become dirty or wet. Please follow the troubleshooting directions below before calling service:

1. Turn you burner to the Lite position:
   
   If you hear clicking or sparking, go to Step 2.
   
   If you do not, check your circuit breakers. If the circuit breaker is ok, we recommend that you schedule service by calling 1-800-432-2737 or schedule service online.
   
   
2. Clean the burner and electrode:
   
   First remove the burner grate, cap, and head. Use a needle or paper clip to poke through the holes on the burner head. Re-assemble and try the burner.
   
   Remove the burner grate, cap, and head. Even if it looks clean, wipe the tip of the electrode with a clean, dry paper towel and PRESS IT DOWN. Re-assemble and try the burner, again.
   
   Check to see if the burner works, If not, then go to Step 3.
   
   
3. Re-assemble - Make sure that each burner top matches its burner bottom. The burner top will lay flat if put on correctly.
   
   Check to see if the burner works, If not, then go to Step 4.
   
   
4. The spark igniter is operating properly, but the burner is still not lighting. At this point, we would recommend that you schedule service by calling 1-800-432-2737 or schedule service online.