I bought a used technic 1200 mk2 it turns on but the turntable wont spin.. anyone know what it could be .. i replaced the start stop button, also the regulators still nothing please help thanks
Need to know if it powers up. Does it try to spin, do you hear it trying to spin? More than likely the on/off switch went bad. No, I am not referring to the ON/OFF knob. THere is a switch this engages when turned. The part is S601. You might also want to replace the Start/Stop switch as well. If neither work, then the issue is on the main PC board, and probably IC101, or IC201 with the problem. At this stage, you will have to have a service tech look at your unit.
Hi Terminal Optic, Yes it gets power. It will spin if you move it manually. I don't hear it trying to spin. I never thought about the ON/OFF knob. The one on the outside moves and of course the whole unit is connected to my sound system. I guess I'm going to have to buy a power manual as this unit is over 23 yrs. old, but has been kept in perfect condition and not abused. So your saying that the PC board could have just went bad, all by itself? How much does it cost to buy a new one that is just as good or better than this one? I sure appreciate your help. I'll look into it.
×
I have the same issue, power button is fine, pitch light, pop up light all work fine, just no drive to the turntable, could it be the an6675 requires replacing?
I have read this on another solution.
This is a Direct Drive turntable. It can have a lower supply issue, microprocessor(computer inside your technics) or the drive circuitry. This will not be easy to resolve, and will require professional service. If you are interested in having your technics repaired, please visit my website at [email protected]. Thank you.
Does the entire chassis get power?
Pitch light, pop up light, strobe light, 33/45 light?
3,833 views
Usually answered in minutes!
yes
YES
I believe I have the same problem. The gets power but the platter won't spin. I took it apart and examined the stop/start switch and it appeared to be fine.
;
On my other sl1200mk2 I took the platter off. When I held a screw driver to the outside of the electromagnet and pushed start I could feel the magnetic field. On the broken table I did the and could not feel it.
i hope there is a DIY fix for this.. I'm broke
Yes it powers up! all lights turn on pitch power ect..I replaced the on of switch from the inside.and one of the little chip things,But still no spin
It's usually the fuses under the platter.
×