Handset screen display gone on BT1000 handset but backlight and phone still work

Hi,

please power cycle the phone unit and check for the display screen when it's on the base again. If still having the issue, please attempt a factory reset of the device. Then, you can setup the phone just as you did when it was brand new. Otherwise, you might have to keep the receiver off of the display in order to allow the screen to show data as it used to.

Thank you.

Hello

When the handset fell down, the flex that connect the screen and the panel has shift. Get a screw driver, unscrew the phone and try to adjust the screen.

If after doing his the problem continues you need to change the screen of the phone.

Thanks

the display unit is not functioning... it is either the problem with the bus(wires) connecting the display and the board, or the problem with the display IC...


backlight is an ordinary led light, it will continue to work whenever there is a power supply to it...

Press and hold the Power button for 45 seconds to turn the laptop off.

Then, remove the battery from the battery compartment and clean the metal contacts.
Next, reinsert the Battery and try to turn it ON.

If the display still doesn't come then you may try connecting an external display to check if the Computer is able to produce display and the issue is with the backlight of the LCD screen.


wish u good luck!!!!!!!!!!!

I purchased this model phone as a refurb item and also had display blanking out issues. Mine related to a problem with the battery, which new batteries fixed. Try swapping the batteries between handsets and see if the fault moves to the other handset, which will prove if it is a battery problem. Otherwise, it would seem to be an internal fault in that handset. Try and arrange repair/replacement from the seller.

if you are good at opening the handset then just open the handset and adjust the display the screen correctly bcoz it will be in loose contact as it fall it might have became loose or the display might have gone one you open the handset and adjust it will work ...

once you press the display screen after opening the panel near edges and in the middle with a little pressure ...

if the display is gone then you can get the new display screen and you can replace that by your self it is easy to do it ...

the display screen of the 1100 is very cheap so no problem if it is gone means ...

if you are not good at opening then just take your cell to the service center he will do it but he may take some service charge ..

i think you can do it ,it is not so much difficult task ..

thank you
regards
-Dileep

rate my solution

my display screen is gone blank....

The solution is this - unplug the base unit then plug it back in. After that it worked fine.

The CP backlights got the problem, try uninstall and install a new light bulb on the phone.

The CP still ok, just only replacing the backlight,