Symbol Spark LS 1004 Problem

If it will not read any bar codes, then it must be repaired. If it only reads selective bar codes, then perhaps the one you are trying to scan may not be of the type it recognizes.

This scanner will read the following codes: LS 1004/LS 1006: UPC/EAN, Code 39 full ASC11, Code 128, Code 93,
Codabar, Interleaved 2 of 5, Discrete 2 of 5; LS 1000: undecoded

Someone mistakenly added a character before the data during the configuration.You may try factory default setting using configuration barcode.

From the LS1203 Product Reference Guide scan Scan Options, Data Suffix, Enter. In the current version of the guide these barcodes are found on Adobe page 47 of 202.

Hello, if all your barcodes have the same structure, it will an easy task. You would need to scan following barcodes from ADF chapter in the Product Reference Guide located at http://support.symbol.com/support/search.do?cmd=displayKC&docType=kc&externalId=5880807apdf
Create New Rule Send Characters Up To Space Character in Alfanumeric Section Skip Ahead 1 Send All That Remains Save Rule
This will by all scanned barcodes send all characters up to the space character, skip the space and send the rest of data.

If the scanner is connected through USB connection, the barcode should appear in the Notepad. If you use the Serial connection RS232, the Barcode data are showed than in Hyperterminal or other application, which is interpreting data from Serial Port.
Please scan the barcode from Product Guide according to your connection. And check the scanned data in an application - Notepad for Keyboard Wedge or USB, Hyperterminal for RS232.

1992 Oldsmobile Cutlass Supreme FWD 3.1 liter DOHC V-6 VIN "T"




1992 Oldsmobile Cutlass Supreme FWD 3.4 liter DOHC V-6 VIN "X"




Hope help with this (remember rated this).

Here at Legacy Global we can help you. Call Diana at 1-847-750-9231.

Here at Legacy Global we can help you. Call Diana at 1-847-750-9231.

The host type are the Interafces which are supported by the scanner directly (no adapter needed). And the Synapse adapter can even an old scanner connect to new interfaces like USB.
As you state you have the adapter for keyboard wedge. You would just need to download the Reference Guide for the "Synapse Smart Cable" at support.symbol.com a configure it acccording to your connection parameters.

What barcode scanner do you have? USB, SERIAL or ps2.

by the way. the old computer is it like NCR, SIEMENS or IBM because then you need to re-program your scanner.

i found a manual where you can set your pc type with barcode scanner. be careful not to scan reset defaults. because you will loose your settings.

look at chapter 4-9 and 4-10

http://support.symbol.com/support/search.do?cmd=displayKC&docType=kc&externalId=3380601bpdf&sliceId=&dialogID=33708056&stateId=0%200%205522749

If you don't know ask me. we don't want to lose al the settings.

good luck