Sharp AR-275 Copier

Toner supply abnormality


check toner motor and DV mag sensor

Here is a list of all Sharp Copier Error Codes

The Sharp AR-M205 is almost 12 years old now. It will be very hard to find parts for that machine unless you can find a low meter on ebay.
You may want to take a look here at some of the current Sharp copier models. It looks like the Sharp MX-M232 replaced this machine.

Hello, You can download the manual here http://sharp.diplofix.com/forum-SHARP/AR-275

It looks like this error is a CRUM chip error, which could be caused by the type of toner cartridge you are using, and or the actual CRUM chip. The connector could be bad (check the connector for the toner cartridge) or when you replaced the toner cartridge; it may have bent the plate that it is mounted on and it needs to be straightened, realigned.

In AR 275 Sharp copier U2 40 is very common problem

try to reset or replace the polygon motor

In AR 275 Sharp copier U2 40 is very common problem, U have to only reset the above error code as fallows

press # then intrrupt then c them intrrupt then display will show simulation mode then enter 16 then press ok key

pl ask for any difficulty

look in the fax manual there should be a section on that
If you have no manual call the company where the fax machine was mad.

To reset maintenance codes requires going into service mode. This should only be done by an authorized trained technician as changing or adjusting something in this mode could create all sorts of problems you dont want to deal with.

what is you OS? check you printer drivers. are they properly installed?, what is your connection between your PC to your printer?, AR 275 can be connected thru network, parallel port, and a USB... they have different printer drivers

In AR 275 Sharp copier H2 00 is very common problem, U have to only reset the above fuser error code as fallows

press # then intrrupt then c them intrrupt then display will show simulation mode then enter 14 then press ok key


If this is not enough then press press thermostat on fuser unit by removing the unit from machine this requires tech knowledge

OR you can try by replacing thermistor of fusing unit

If by above procedure the prob is not solved then and then you replace the fusing lamp

Even though u can check the lamp by removing back cover and turn on the machine u can observe the light of fusing lamp

pl ask for any difficulty.