Oven Will Not Start

We bought this oven too for our newly renovated home, we used it for six days before it failed due to an electronic error (F6E6: Appliance Manager 1 Board Communication). After a failed warranty repair attempt and multiple phone calls/complaints we eventually got Whirlpool to agree to give us a new oven. We had to wait six MONTHS for this new oven to arrive due to it being out of manufacture. Our second oven arrived and worked for 8 weeks until this weekend, it failed again with an F6E6 error! Now to try and get it repaired replaced!

There is obviously something wrong with the electronic design or poor-quality components are being used. We strongly recommend you do not buy this oven.

We bought a matching combi oven from the same range which means we have to stick with this oven or we will end up with ovens that don't match in a brand new kitchen!

[PDF]Viking Use & Care Manual

www.vikingrange.com/MEDIA.../m1300016_f20366.pdf

Viking Rangecontact our consumer support center at 1-888-VIKING1. We appreciate your choosing a... Error Handling .... *Note: Professional Series Premiere model control panel and features are shown. Oven ... upper or lower oven, and then set the desired temperature. .... cooled, remove any ash from oven surfaces with a damp.

well, at least your door hinges are still working. Let me guess, this is less than 6 months old. Every review of these ovens shows the door function breaking. I wish I had better news...and good luck!

F2-E0 Shorted Keypad Replace Keypad

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Hi


Thanks for using FixYa. Error F2-E0 on your kitchen aid means that the keypad is shorted and to resolve this issue you’ll have to replace the electronic range control/clock (ERC). Please do rate the solution if the issue is resolved or post a comment for further assistance.


Thanks
Rylee

Sometimes you can get lucky by pressing all keys at random several times each. If that does not work you will have to replace the keypad.

hi friend,
error:FR
condition:second oven error sensed
resolution:1.check oven temperature sensor and hardness[or]
2.replace second board
hope this helps u
thank u for using fixya
please rate me....................
regards
sivaranjini

Sounds like leaving the door open has possibly cooked the controller. I would try a power cycle - power off at fuse for 5 minutes, then reapply power. If this doesn't clear it, you may need a new controller for it.

Try this first!
The control panel has a flat ribbon cable that plugs into the relay module. The ribbon is actually two ribbons pressed together. The plastic insulation has a defect, and the leads between the two ribbons cross. You can seperate them easily by lifting them apart. Place a piece of paper between them to act as an insulator. This should solve your problem. If that does not work, repalce the defective parts yourself. You can do it for about 30% of what a repair company would charge. it's either got to be 1. Control panel 2. Relay panel. Good luck!!!