I have perused posted problems and suggestions and I think that my paper feed roller needs a tension adjustment or a replacement. There was one reply with directions for adjusting tension that I couldn't figure out because taking off the back door to the printer didn't give me access to anything. I also have cruised the web looking for a way to order said part and have come up empty-handed. Any suggestions for adjusting the roller or getting a replacement part would be welcome!
Will print??? or the paper not coming out of the draw does it work using the bypass tray???
Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f
SOURCE: konica minolta magicolor 2400w printing proplem
pleas check transfer belt, and drum unit, probably these lines are caused by drum unit and you have to change it. also you can clean laser glass, what is under the drum unit. if both look fine you can also look at the fusing rollers.
SOURCE: Konica Minolta Magicolor 2400W -- Only Prints on Reboot!
I've had that problem before too, and found out that there were copies of the printer that had somehow installed themselves on my computer. All I needed to do was to choose to print with "konica minolta copy 1" instead of the one that I *thought* was installed and it worked. I then deleted the original printer and just stuck with the copy.
SOURCE: Konica Minolta Magicolor 2400W drum cartrige-how to replace?
Did you buy a whole new drum unit, or just change the cartridge? If so, the fuse may still be blown. Also, you may need to empty the spent toner out of the old cartridge.
SOURCE: Konica Minolta 2400W Magicolor. Error light blinking
Ready indicator Error indicator Condition Action
Green Orange
Blinking Blinking Communication Check The Printer
error cable
____________________________
Print over-run Turn off the printer.
After a few seconds
turn on the printer
change to a lower
resolution.
________________________________________________________
This may help if not...let me know........Whytfang
SOURCE: I have a Konica Minolta magicolor 2400w printer I
For the language problem, reinstall the printer driver, selecting "EN" for the language to be in English, not "ES".
For the print problem, there is not enough information to diagnose. Please detail the symptoms. If you meant indicate that the printer recognizes an attempt to print, there should be a message on the LCD panel and certain LED lights indicating what is happening. We (the solution providers) need to know exactly what that is.
403 views
Usually answered in minutes!
×