Sony KP-57WS510 57" Rear Projection HDTV Logo

Related Topics:

A
Anonymous Posted on Dec 25, 2013

Sony model kp-57ws510 timer/stand by light blinking 6 times can't turn on tv t all

Tv shut off timer light blinking 6 times cant get it to turn on at all

5 Related Answers

Anonymous

  • 4402 Answers
  • Posted on Dec 20, 2007

SOURCE: SONY KP-57HW40 TUNS OFF AND STANDBY LIGHT BLINKS 6 TIMES

6 blinks is usually associated with failure of the horizontal deflection amplifier - which shuts down the high voltage system as well.

The repair requires testing to determine the exact parts that have failed. There are, for example, a few hundred parts and a section of the Jungle IC chip involved. So, repairs could require something as simple as replacing some inexpensive passive components OR as complicated as replacing the jungle chip (very expensive).

most of the time it's the horz. transformer and transistor.

Ad
Slinteriors

Sonny Berry

  • 8617 Answers
  • Posted on May 27, 2008

SOURCE: SONY REAR PROJECTOR TV

5 blinks means AKB detected. Try turning down all 3 screen adjustments slightly.

billyjones69

billy jones

  • 42 Answers
  • Posted on Nov 16, 2008

SOURCE: 6 bliks on sony kp-46wt510

KP46WT510 Shutdown 6 Blinks. 6 Blinks = Low B+ OCP/OVP
SOLUTION: Replaced Flyback transformer. It had no rings on the ringer test.
HQ
Comments: Any load on the B+ line can cause 6 Blinks.
Example: If the 200v line is loaded down will cause a drop in B+ due to bright picture current demand.

Click Here! to download the Sony Kp-46wt510 full service manual.

ginko

Ginko

  • 19396 Answers
  • Posted on Dec 01, 2008

SOURCE: Sony Wega stanby light blinks 5 or 6 times

When a Sony TV flashes five times, that means that there is an AKB circuit fault.
Six blinks is also a fault related to video problems, and regards a fault concerning the digital board and the Jungle IC (the main CPU).

This means that there is something wrong with the video.
Try first unplugging power for few hours, if that does not work, call a technician, as several IC and components must be tested and eventually replaced.

Anonymous

  • 5138 Answers
  • Posted on Dec 28, 2008

SOURCE: How to change convergence ICs in Sony KP-57WS510 TV?

Replace Both STKs convergence ICs big black ics with number on them STK392-560.Parts 1-800-223-3205

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

My tv is not turning on but the stand by light is still on.

The model listed does not have a standby light, only the power on/off light which is there in case the set does not make it on to blink a error code--specific number of blinks

before going further can you confirm the model number and add if have sound, or menu etc?
0helpful
1answer

Sony kp-57ws510 timer/stand by light blinks 6 times. no picture or sound. Whats wrong?

the best moment to starting is the VIDEO DETECTOR,+Audio i-f and by splitting your can troubleshooting and fix it. see the b.diagram attached.


10_1_2012_10_50_38_pm.gif
0helpful
1answer

Sony KP-57WS510 red light blinking 5x

Try connecting the TV directly to a different wall outlet and check. If the issue persists, try power resetting the TV. Turn Off the TV and remove the power plug from the wall outlet for 1 minute and reconnect it and check the operation. If the issue persists, then the TV requires service.
5helpful
2answers

Try to turn on, it turns off right away and the stand by light flashes 6 times

Hi


Thanks for using FixYa. Standby/Timer light blinking 6 Times means no Horizontal (H STOP), no raster, and so the set goes to the blinking self-diagnosis function immediately. You’ll need to open the back off the TV and check C515 & 516 and the jungle IC, IC206. Also check +5 line is overloaded (A, B boards), +5 line is shorted (A, B boards). Please do rate the solution if the issue is resolved or post a comment for further assistance.



Thanks
Rylee

0helpful
1answer

Tv turns on for 5 seconds no picture and shuts off.. red light blinks 8 times

hello. problem with the audio (AUDIO), unit goes to standby and blinks the self-diagnosis code. Check IC406 audio amp, PS401, and 402. On some projection models of Sony TV sets, this code means that T8005 (flyback transformer), or the associative components in the high voltage circuits are defective on the D board.

shaun
4helpful
2answers

Sony KP-41T65

is there a cadence to the blinking timer light?
0helpful
1answer

Red light flash timer stand by

Please count standby light blinks and let me know.
There would be pause of 3 seconds in blinks.
Also confirm is it Sony KP-57HW40 model?
14helpful
3answers

Timer Standby light flashing No pitcher

Sony
Model # KP-53HS10
Serial # 9718217
MFG 2000

Plugged in TV. Timer Standby Light just flashes continusly. No Picture and No Sound.
0helpful
1answer

Blinking

Can you do this? Take the back off and look next to the transformer (has large red wires coming out) and have someone turn on the set and if you see a glowing device next to the transformer then the High voltage splitter is bad and if no glow then transformer is bad. This is for information purposes only. Changing these parts is for the trained only and could cost on average $300 parts and labor depending on the repairman and location you are living.
Not finding what you are looking for?

143 views

Ask a Question

Usually answered in minutes!

Top Sony Televison & Video Experts

Grand Canyon Tech
Grand Canyon Tech

Level 3 Expert

3867 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

matt martin
matt martin

Level 3 Expert

1259 Answers

Are you a Sony Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...