Need factory default combination

• Open your Sentry safe by typing the five-digit factory code (found in your owner's manual) on the keypad. It's always a good idea to change your combination while the safe is open, so that you don't inadvertently lock yourself out.
• Delete any existing codes by pressing the "P" key and entering the factory code, followed by "00000." On older safes, press the "PROG" key and entering your factory code twice to delete old codes.
• Press the "PROG" or "P" key again on your Sentry safe's keypad.
• Enter your safe's five-digit factory code.
• Enter a five-digit code of your choosing within 5 seconds. This is your user code. While the factory code cannot be changed, your user code can be changed as often as you like, and that should be your primary code to open the safe. Only you should know your safe's factory code.
• Retype the user code to verify it is working, and then close the safe.

Contact brinks they may have a master code to unlock your safe...or try a good lock smith,they may have access to the code.

To reset the combination on the Paragon 7875 Digital Keypad Depository Safe, you will need to locate the reset button on the back of the safe. Once you have located the reset button, press and hold it for 3 seconds. This will reset the combination to the factory default of 0000. You can then enter a new combination of your choice.

All you have to do is find your owners manual the sentry safe combination was posted in. Unless you locked it the safe as happens all the time. After all that is the safest place for it right. Or you can just call a locksmith service tech

The factory code combination to your electronic lock will remain in the memory of the unit - even if the batteries go dead. Any use programmed codes will be lost if the batteries lose power. The Sentry programmed factory code is always your default code.

If you do not know your factory code, you can follow this link for your combination retrieval:

http://www.sentrysafeshop.com/Lost-Combination-Sentry-Safe-Combination-p/lost%20combination.htm

Welcome to FixYa.

How to reset or change your lock combination:

• 1. Enter "zero" six times.
• 2. Enter your existing six (6) digit combination one time. (or 123456, factory default if you haven't changed the combination yet.
• 3. Enter your NEW six (6) digit combination two times.
• 4. If a mistake is made wait thirty (30) seconds and repeat steps 1 - 3.
• 5. Test lock operation several times before closing the door.

CAUTION: When selecting a combination do not use birthday or other predictable data that could give correlation between the user and combination.

• Valid Combination Entry - Double signal after valid six (6) digit combination is entered.
• Invalid Combination Entry - Triple signal indicates the old combination is still valid.

Thank you for using FixYa.
Have a great day.

Jas247

If the safe is brand new.. you must first remove the locking screw at the base of the combination lock dial lockcase.. discard the screw.. Make sure you have the owners manual with the sticker and default lock code nearby before locking the safe.

The factory has a preset combination code that cannot be deleted. It is on the owners manual. You can use that code if your codes have become compromised.

Also ensure the batteries are fresh. This may also be the problem.

Anything beyond this will require assistance from Sentry. Your serial number is on the side of the door. Have that ready.
www.sentrysafe.com

Best of Luck

The factory code combination to your electronic lock will remain in the memory of the unit - even if the batteries go dead. Any use programmed codes will be lost if the batteries lose power. The Sentry programmed factory code is always your default code.

If you do not know your factory code, you can follow this link for your combination retrieval:

http://www.sentrysafeshop.com/Lost-Combination-Sentry-Safe-Combination-p/lost%20combination.htm

go to the electronic shop and ask for assistance.