Where can you purchase Siemens parts in the USA? We've just begun our search for a drain pump for our WFXD5200UC UltraSense Washer. Thanks

ck out this........

https://www.how-to-repair.com/help/faqs/siemens-washer-wfxd8400uc-wont-spin/

https://www.manualslib.com/products/Siemens-Ultrasense-Wtxd5300us-2952500.html

This error indicates a fatal error with the control board. A replacement board for the WFXD5200UC is available here: http://www.repairclinic.com/Shop-For-Parts/a11b129i1995d691201/Model-WFXD5200UC01-Bosch-Washing-Machine-Main-Control-Board-Parts .

Before you replace the board, you may be able to reset the error code. Start with the washer off (the knob will be at the 12 o'clock position) and the door closed. Turn the knob to the 6 o'clock position and wait 2 seconds. Press and hold the spin button while you turn the knob to the 7 o'clock position. Wait another 2 seconds and release the spin button. Turn the knob to off. You may need to repeat this up to 6 times. If the error continues to appear, the board is faulty.

If the washer is under warranty, contact Siemens. I hope this helps.

Cindy Wells

only order if the surrounding rubbers in the lower pipes have perished otherwise strip it out give it a good clean and re-attach

According to siemens website Laundry appliances use many different codes depending upon age and origin. Faults that can be dealt with by the user are normally listed in the instruction book. Link to instruction manual download Flashing LEDs or displays frequently indicate door not closed, low water pressure or a blockage in the drain pump, drain hose or your drainage system.

most washer are set up pretty much the same ill do this by number so you can follow
1 make sure you empty washing machine either by spin cycle or manual drain through kick flap at front make sure you have rags towels bowl 2 unplug the plug from electrics 3 turn water supply off at wall disconnect water inlet pipe 4 now all electrics and water are disconnected you need to disconnect the drain hose usually attach to drain pipe behind wash be careful these are usually full so drain off 5 if you can manage yourself carefully put washing machine on its side put some towels down to protect 6 underneath usually to the front right bottom is the sump pump with the sump hose black and the drain hose grey and the manual drain hose now either by clip or screw loosen the drain hose it is usually attached up the sides by clips they can just be pulled off one free from the sump motor just pull it through if refitting remember its just all reversed what you have done good luck

Here is a link to the part I think your looking for.

oh your gonna have so much fun with this sorry i had this model before and its one of those omg type of units. have you opened the pump door and checked inside the pump most of the times this is the problem first off another thing that these lovely little devils do is they have these small screens inside the rear water valve really small as in inside the tube that goes into the machine remove each of these and wash them thoroughly the smallest speck of debris on these small screens causes these not to run hope this helps write back if this doesnt fix your situation well go more in depth at removing alot of things in order to track down your problem youll find another thing funny also that if you were to remove the cover the entire technical sheet is in german

your best bet is siemens web site get their contact page and call them for a dealer phone #

Is the pump out motor working ?