Eiki LC-XG110 lamp going off

Check the lamp. If it is not blown then there is a problem in the lamp ballast circuit and the projector will need to be serviced.

broken lamp or ballast unit
both are costly

these are the signs of a broken bulb or a failing lamp ballast unit.
this is a aged model, better spend your money to a new machine

Please check on of these solutions :

1:Remove the lamp from the projector. Ensure that it has no cracks, discoloration or "smoky" appearance.

2:Try removing and reseating the lamp, or to try another lamp.

3:Reset your lamp timer. Most projectors have no way of knowing if you physically have replaced your lamp. They rely on the user resetting the lamp timer

4:Pull the lamp back out of the unit, give is a brisk shake and reseat the lamp. Occasionally there is some buildup on the lamp contacts or filament during manufacturing.

5:Are the input and output vents blocked or obstructed in any way?

6:Are the filters dirty or clogged? Most manufacturers will recommend filter cleaning on a monthly basis depending on usage

7:Remove any extension cords, power strips and/or surge suppressors. Many current model projectors will not even try to ignite the lamp if they detect drops or fluctuation in voltage supplied to the unit. This is a safety feature to reduce stress on the lamp.

PLEASE DON'T FORGET TO RATE !

Owner decided to upgrade to a newer projector. Lamp was too expensive.

the lamp is near the end of it's life. time to replace it.

either the lamp cannot strike (meaning a ballast or lamp issue) or there the fans are not up to speed to sufficientl;y cool down the lamp and therefore shut down to avoid damage.

check the following :
1.does the lamp glow
2.do u get the connected image
3.if yes does the screen show temperature or overheat
4.if yes then one of the cooling fans do not work properly & hence the unit turns to standby & goes into protection
if no 1 does not happen, then check the lamp physically,it should not show melted or breakage.
if the lamp seems ok, then the ballast is defective!

Clean air flow filters

Hi there

This sounds like a common Ballast ( lamp's power supply ) problem.

Only way to rectify this is by replacing the faulty Ballast.