Green light is off or blinking

A blinking green light on a Segway Ninebot charger typically indicates that the charger is properly connected and charging the device, but the battery is not yet fully charged. Once the battery is fully charged, the light should turn solid green. If the light continues to blink green and the battery does not charge, it could be an issue with the charger or the battery. Try using a different charger or testing the charger on another device to see if it is working properly. If the issue persists, contact Segway Ninebot customer service for further assistance.

Same problem here... Blinking green light. Purchased new battery and is still doing the same thing. Very disappointed-these cameras are not cheap. :(

If Try one or more of the following

Ready light does not turn on and the camera does not work.

• Turn on the camera (Turning on the camera).

• Install new batteries (Loading the battery) or charge rechargeable batteries.

• Turn camera off, then back on.

Ready light blinks green.

• Camera is operating normally.

Ready light blinks amber.

• Wait. Resume picture taking when the light stops blinking and turns green.

Ready light blinks red and camera turns off.

• Install new batteries (Loading the battery) or charge rechargeable batteries.

Ready light glows steady red.

• Transfer pictures to the computer (Transferring pictures with the USB cable), delete pictures from the camera (Deleting pictures/videos), switch image storage locations (), or insert a card with available memory (Using an optional SD/SDHC or MMC card).

• Wait. Resume picture taking when the light turns green.

• Change the image storage location to internal memory (), or use a different card.

Ready light is off or glows steady green.

• Camera is operating normally

whenever i plugg it in it blinks green but then the light turns off how do u kno if its done charging???

The green light blinking in the back indicates that the power supply went bad and is not turning on, go ahead and get the power supply replaced. Normally that light is supposed to be fully lit and green.

Red light indicates that the camera is out of charged., Try to charged your battery for 3-4 hrs if you encounter flashing red on a fully charged battery you need to call kodak 1 800 235 6325 ext 12

You can charged you camera using 5V AC Adaptor or a USB cable taht attached into the computer

Try cleaning the contacts on the memory card with a pencil eraser.

make sure that all the cables are connected FULLY.
blinking light means that there is no signal.

i was filming, and i tripped and my gl2 hit the ground. it hit the battery kind of hard and now it wont work properly. now when i turn it on, the power light blinks red or green, depending on playback and recording mode. i want to know how i can fix this.

I followed the advice of my Fixya adviser--remove the battery for 3 minutes then plug the USB cable into a different port on my computer and plus in the camera. I did that and turned the camera on as advised but the green light still did not blink. The adviser did not respond when I asked what to do next so I disconnected the camera from the computer and plugged it into the charger. This time the first blue light started blinking (nothing happened when I tried it before following the Fixya advice). I left the camera to charge all night and eventually, after about 12 hours, it did.
Seems O.K. now.