The Crush option is currently selected and I can't change it to Water or Cube. I can push the Water selector maybe 10 times and it will switch for one second to Water and then go back to Crush.
SOURCE: water/ice dispenser activates at will, selector panel locks up
Hi jrupich,
There is only two things that can cause this problem. One would be the dispencer control board. Part #61003425
The other thing is a stuck or shorted dispencer switch
part #61005520
Since you say that you have already replaced the control, I would have to go with the switch, but in rare cases the new board installed in the dispencer can also be faulty. Some appliance techs will even sell you a used one and tell you it is new. You have to trust your repairman. Good luck to you and I hope this will FixYa. please dont forget to rate me.
Mike Anderson (Owner)
Anderson Appliance
(865)945-3808
SOURCE: Change water filter for a maytag plus refrigerator
press the light switch button inside of the refrigerator five times.
SOURCE: I have a Maytag Plus
Normally you just need to hit the unlock button in for 10 seconds.
If this not works, here is what you need to do -
Note: If dispenser is active for more than five
minutes, an automatic lock out sensor will shut
down power to dispenser area.
Dispenser Lock/Unlock
The Dispenser Lock and Unlock affects all keypad functions.
To Lock Dispenser:
seconds. A green indicator light above the button will
illuminate when the dispenser is locked.
To Unlock Dispenser:
green indicator light above will go out
Otherwise your refrigerator has a preset shut down program that protects the
dispenser from flooding your kitchen. The control will shut down and
will NOT reset when unplugged. The control needs to be
reprogrammed. This mode was triggered by drawing out water for too long
of a period of time. Call a Maytag service dealer.
71 views
Usually answered in minutes!
×