Train lights up but doesnt move - Fisher Price Geotrax Remote Control Train Demolition Team

Try new batteries in the controller Be sure they are in correct. The LED light should come on when it has power. Try moving closer to the train. Usually when the red light is flickering is when there is an engine problem. But here is the Manual just in case you did not have one. Also it has a number for lionel Service in there. Good luck. =) http://www.lionel.com/media/servicedocuments/60287110222501.pdf

clean your track & wheels.

check the battery and the charger with a multimeter and make sure they are showing the correct volts, and then check the voltage wires where they connect to the motor and see if its showing the correct volts there when the foot pedal is pressed

Have you let the loco charge first? The instructions are a bit vague but the loco needs to charge before it runs. Not easily understood from the instructions and many have spent some frustrating minutes wondering why their train wouldn't move.

sounds is run by 3 aaa batteries under the smoke stack and train is run by 6v battery under the seat, 6v battery probably need to be connected or recharged

the whistle runs by three aaa batteries, the train engine runs from the sla battery, verify that its connected correctly

the music is run by three aaa batteries so that will work no matter what, did you reconnect the battery to the vehicle after charging it

The red button on the right must be held down for anything to move. It turns the lights on, makes some train noises, then moves forward. If you don't hold the button down, nothing will happen. Note that when the train is underway, the left red button becomes a train whistle. Otherwise, when the train is not running, that left button produces music. Hope this helps.