KDC-MP522 portable dvd player to kdc-mp522 auxiliary input. i cant find the auxillary.

Step 1:

Enter Menu mode
Press the [MENU] button for at least 1 second.
"MENU" is displayed.

Step 2:

Select Clock Adjustment mode
Press the [FM] or [AM] button.
Select the "Clock Adjust"/ "CLK ADJ" display.

Step 3:

Enter Clock Adjust mode
Press the [Down Search] or [Up Search] button for at least 1 second.
The clock display blinks.

Step 4:

Adjust the hours
Press the [FM] or [AM] button.


Adjust the minutes
Press the [Down Search] or [Up Search] button.

Step 5:

Exit Clock adjustment mode
Press the [MENU] button.


Hope that helps.

Cheers,

Scott

It don't work like that. Each individual head unit has a seperate PIN code. Best bet is to get the serial number from your unit. Located on top or back of it, and call Kenwood direct with the serial the serial number, they have all codes on file, they can help. Here are the numbers

Kenwood Australia - 1800 126 659
USA - 1-800-KENWOOD (536-9663

If not either of them, go to their site
http://www.kenwoodusa.com/Contact/

You can get the wire diagram on the link below page 31.

http://manual.kenwood.com/files/B64-2516-00.pdf

the auxiliary input if you want another drive device system, like you want to play mp3 connect into auxiliary.

that is kind of strange and if your getting power to put a cd in but no for it to fully power the unit you may need to check another fuse it will be not be your radio fuse but instead a mini fuse in your vehicles cabin should be on the left side under neith the dash or on the side of the dash it will most likely be a 10 or 15 amp mini fuse that supplies power from the fuse box to the reiceivers acc source ignitions source

If your lasers eye is dirty the just use a cd/calibrater disc They are cheap and the have a small brush with hairs on the disc that clean the surface of the eye.

how do i reset my cd played and get pass the code

puedo desbloquear una radio kdc-mp522 sin el control remoto

it needs to be replaced, I'm a service tech @ a kenwood dealer, if you are intrested in getting the part or having it fixed email me

[email protected]


Don

Try putting the unit in standby via the "SRC" button FIRST..., then press the menu button and cycle through to the "AUX 1" option and activate this....then press menu button again. When the unit is next switched on, you should have an "AUX" option accessible via the "SRC" button which will cycle through all of the availale modes ....standby-tuner-cd-aux etc etc.