How do i get my K/bootstrap/logger.js to work

.js file is a java script, make sure you have the latest java installed on your computer.
Also pay attention what version you have 32bit or 64bit and download accordingly.

this is the bad file
/**
* Wrapper for logging.
*/
function log(s) {
if(typeof(console) == 'object') {
if(navigator.userAgent.toLowerCase().indexOf("applewebkit") != -1) {
console.log(s);
} else {
console.log.apply(this,arguments);
}
}
}

that file is held on your computer...... nobody can help you unless you post it.

just click the red button "share" on your camera, then disable sharing, if you have the device connected to a computer, automatically it will open the content of your camera as if were a pendrive or an external hdd, problem solved.No need of kodak addon software.

if you issue the command show version
At the bottom written in bold you should the config register settings these nee to be as shown at the bottom of this page


R1#show version
Cisco Internetwork Operating System Software
IOS (tm) 2500 Software (C2500-JS-L), Version 12.1(3), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-2000 by cisco Systems, Inc.
Compiled Thu 06-Jul-00 10:02 by cmong
Image text-base: 0x0306F914, data-base: 0x00001000

ROM: System Bootstrap, Version 11.0(10c), SOFTWARE
BOOTFLASH: 3000 Bootstrap Software (IGS-BOOT-R), Version 11.0(10c), RELEASE SOFT
WARE (fc1)

R1 uptime is 1 day, 5 hours, 39 minutes
System returned to ROM by power-on
System image file is "flash:c2500-js-l.121-3"

cisco 2500 (68030) processor (revision N) with 14336K/2048K bytes of memory.
Processor board ID 11844920, with hardware revision 00000001
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
TN3270 Emulation software.
Basic Rate ISDN software, Version 1.1.
1 Ethernet/IEEE 802.3 interface(s)
2 Serial network interface(s)
1 ISDN Basic Rate interface(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read ONLY)

Configuration register is 0x2102

if yours differs the use the these commands to correct it


R1>en
R1#conf t
Enter configuration commands, one per line. End with CNTL/Z.
R1(config)#config 0x2102
R1(config)#^Z
R1#


Hope this helps

Bootstrapping means

• "To load and initialise the operating system on a computer"

word comes From "to pull oneself up by one's bootstraps"
Check this detailed explaination at Wikipedia and at Khmere.

Try this site. I have used Ghost Key Logger. Works well. Beware that spyware and antivirus programs WILL see this program and warn you about it.

http://www.dirfile.com/freeware/keystroke-logger.htm