Dell 230 schematic - Dell Vostro 230 PC Desktop

Contact Bernina directly to inquire about availability of diagrams.

start on page 17. this should be done by electrician. pump is 230 vac and there must b a different wiring to use 120 vac. Call an electrician, and stop replacing igniters.


https://www.jandy.com/~/media/zodiac/global/downloads/h/h0248900.pdf

Press F2 on boot up to enter the BIOS. More info can be found at Product Support Dell US Manual
All other info Product Support Dell US

If it was a DC motor it wouldn't run on AC. If it hasn't been used for a long while it might smell while the dust and grease burn also the bearing(s) could be dry, make sure it turns freely and smoothly and nothing gets too hot. Check current with ammeter

Hi Robert,

Simple answer is no, but if you still require help with programming, may I suggest: Join yahoo group specific to your radio Make/Model, they have all the info plus you can download manual, schematics and other goodies.

I hope I have been of assistance.

Regards,
Peter

If you are sure the graphics adapter is gone, you have check ALL cables, connections, try another monitor/ cable, drivers: http://www.dell.com/support/drivers/us/en/04/Product/vostro-230. A Graphics card is a option, make sure to look at the min. requirements for the graphic card, the power specs are important. I would not change the BIOS if Dell does not require it.

Your computer is toast! If it was submerged in water, your motherboard, hard drive, memory and power supply are contaminated.

look on the motor ID plate it has a diagram how to set voltage

what brand and model speakers? Dells require powered amplified speakers

Don't! That's for foreign voltages. It should say 115 and 230. The 115 is for 120V systems while the 230 is for 240V systems. The actual voltage you get is usually a little less than ideal, so they design power supplies to accept a lower voltage.