The door handle on my GE Profile ADvantium 120 Microwave is broke

go to ge or any online appliance parts site use make and model and look up your part numbers

Normally you have to separate the door panels (as shown in the attached photo) and then you'll see the screws you need to remove.

Or you can watch a YouTube video (not a video I made) here that demonstrates how it's done.

The actual Advantium 120 service manual is at our site here.

You can find handy exploded views and order parts by model number here.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

A missing or unreadable serial number relieves the manufacturer of all responsibility for any warranty, so all parts and labor cost will be on you.

For future reference, the service manual is here.

You can order parts and accessories here.

You can download GE owner's manuals and installation instructions here.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

Hi,
Here is a tip that will help you to figure out what is wrong with yourMicrowave Oven....

Microwave Oven Basic Troubleshooting Tips

heatman101
kjf

check out www.repairclinic.com have your information available for them (e-mail)

There may be advertisers here at Fixya also that can supply this part. Im sure the company would appreciate your supporting those advertisers.

Thanks for using Fixya

a

The handles are usually held on by two screws which are usually visible on the back of the door. The handle itself should be available at some of the parts suppliers who sell on the internet.

Of course it is.  You can glue it on with gorilla glue, perhaps using a screw shaft (be sure to drill pilot holes) like a dowel in carpentry to secure and add area for the glue to adhere to.  Drill the pilot hole in the handle bit the thread diameter rather than the shaft diameter, so you don't have to screw the handle on once you cut off the screw head.

If it's just the bottom one and you don't want to disassemble things to reconnect things right, drill a pilot hole in at an angle through handle and door to permit screwing in a wood screw to fix it up.  Brutish, yet sexy.

Check out this door frame diagram, specifically number 1805. It clips on to the door frame. Remove it using a dull table knife or something similar (be careful not to scratch or break anything). You will then have access to the bottom screw.

I used a form of hot stuff glue and it worked just fine!!