Take another look at the answer above by spamslisher. This was exactly the problem I had. The control panel gave four quick beeps every ten seconds and the treadmill would not start or respond at all. The problem was a stuck button on the control head. That diagnosis was thanks to the tip from spamslisher above. I tried all the keys until I found one that didn't beep. That was the stuck key. In my case it turned out to be the down arrow on the ifit row, same as for spamslisher. After opening up my control panel it was easy to see how to disconnect the ifit control board from the main board. I did that and my problem was solved. Like spamslisher, we never use the ifit feature anyway so nothing lost there. Thanks for the really helpful tip. I doubt I'd have figured it out without you.
SOURCE: My Nordic Track treadmill has has 10 speeds (1mph
You should have a speed arrow up & down, this increases and decreases the speed in .1 mph. Try this control and see how the unit re-acts if the speed does not adjust in .1 mph increments or it stay the same either way it sounds like an upper board issue. Go to iconfitness.com go to customer service the replacement parts put you M# and will give part# and pricing.
RULE OF THUMB: IF REPAIR IS MORE THAN THE THE PURCHASE PRICE OF UNIT DOE NOT REPAIR
SOURCE: BUYER BEWARE!! I purchased
Watch this video: o 1 Ensure that the treadmill is plugged into a grounded outlet using the correct surge suppressor. Use a UL 1449 suppressor listed as a transient voltage surge suppressor (TVSS). It must be rated for 15 amps and 120 volts AC. Secure the services of an electrician if the outlet is not grounded, or move the Proform treadmill near a grounded outlet. Do not use an extension cord. o 2 Insert the safety key fully into the display. Treadmills with keys are designed not to turn on without the safety key in place. o 3 Find the circuit breaker on the front of the frame and make sure it is not tripped. The circuit breaker is a vertical switch on the 540S and a horizontal switch on the 540 Interactive Trainer. Press it to the "Reset" position, which will be labeled. o 1 Unplug the treadmill and remove the safety key. o 2 Move the upright base of the treadmill down with the help of another person and lift the uprights so that you can get to the underside of the console. Use a Phillips screwdriver with at least a 5-inch shaft to remove the screws. There are five hood screws on the 540 Interactive trainer and four screws on the 540S. o 3 Remove the motor hood to get to the small reed switch by pivoting the hood off the frame. Find the reed switch and magnet, which are on the left side of the pulley for both models. o 4 Turn the pulley with your hand until the reed switch aligns with the magnet. There should be 1/8-inch gap between the two. Fix the distance so that it is 1/8 inch by loosening the reed switch screw and sliding it to the correct distance. Tighten the screw. o 5 Reverse the directions to put the hood back on and the treadmill upright in the original position.
http://www.youtube.com/watch?v=E-q-uS4t6so
1. Power
2. Reed Switch
Check too:Optical Sensor. If have it
SOURCE: How do I disassemble the Nordic Track t5 zi for transporting?
Please read you owner manual.
If you do not have please go to www.nordicktrack. com then customer service and then parts & manual, give you model, etc, and download free and read the section how to fold and viceversa.
sincerely
2,453 views
Usually answered in minutes!
×