Tax rate reset

Press AC twice Hold down % set key for 4 seconds. Input tax rate (6%). Press Tax+ key, then press % set key
Source: http://www.casionz.co.nz/Site/CASIO/files//settingandusingtaxandexchangekeys.pdf

Youll find your answer right here in the manual:

 

http://www.retrevo.com/support/Casio-DR-210TM-Calculators-manual/id/12440bh226/t/2/

 

800kb pdf file.

 

Hope this helps. Good luck!

 

kc

Hi,
Try the link below.

http://www.casio.com/support/techsupport/calculators

SETTING YOUR TAX RATE
you hold your set % button down for three seconds until set shows again, then hit tax rate button it shows your tax rate, change your tax rate then hit set your tax rate should be set.



cliff notes:
hold set% button
hit tax+ button
change the desired % 
hit set done


Do rate the solution.

I found my manual papers.

Push the CA button
Hold down the set key (%) until the 0 prints and shows on the screen.
Then type in the new tax amount and hit Tax+ .
You will also need to repeat the above for the Tax- .
This works for my DR-220HD Casio Calculator.
Good Luck

To change tax rate on Casio DR-210TM:
Hit <CA>
Hold <%> for 5 sec until '0' re-appear
Enter 'Tax Rate' and <TAX+>

First hit "CA" Key. Then hold down the "%" key for 3 seconds. Then input the tax rate. Next hit the
"TAX +" . Then hit the "%" again. You are done. make sure the printer is on.

Found this on the casio site worked fine on my ms-120TE
1. Press [AC]
2. Hold [SET/%] key for about 2 seconds until set and a 0 is displayed
3. Press [TAX+]
4. Input the tax rate
5. Press [SET/%]

this is the link:- http://www.casio.com/support/content/AF64A1AC-193D-4650-A9A9-98BB6FE26CFE

make sure you are in "print mode" step 1 pess the AC button step 2 press and hold for two seconds the % button step 3 press the tax+ button step 4 input tax rate step 5 press the % button now check to make sure that is correct.

Printing models (except HR-8TE): 1. Have calculator in ?print? mode 2. Press [CA] 3. Hold [SET/%] key for about 3 seconds 4. Input the tax rate 5. Press [TAX+] 6. Press [SET/%]