Hit the "clean " button on my gas stove. Not only did it not clean but the Door locked button has been flashing for 2 weeks. Everytime I go to cook and it the Bake, Broil key it flashes DR then F9 I h

6ya staff

• 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Instant Repair Help over the Phone

6ya.com

Save Time & Money by instantly connecting to...

Posted on Jan 02, 2017

SOURCE: model fgf337asa

Turn your gas knob to ON position. Let me know if it does not work,

Posted on Jul 26, 2008

SOURCE: oven door cannot unlock

I know this response is a bit dated, but I just had the same problem. I removed the back panel. There is a little motor that turns the locking mechanism. I removed that and there is a button on a sensor next to the motor. I turned off the power first, since 220 can kill. Then when everything was sorted out, i turned the power back on, hit the switch on the sensor and everything is back to normal. I also made sure that the lock in front was back at 12 o'clock (the L shaped piece at the top of the door, but on the stove),. It worked for us. Good luck.

Posted on Sep 10, 2008

Thomas Malailua

• 311 Answers

SOURCE: bake or broil does not work

if an element itself had shorted it would not stop the other from working and you could inspect each element and see blistering as evidence.the pop you heard has to be in common with both elements but not the cook top[burners]so thats going to be the wiring in the back of range, or switching,[thermostat,clock timer or oven selector switch,depends on which model you have]you will have to pull range and remove back pannels.you will find an obivous burn't connection.too repair all new connections must be clean and tight,or will burn again.

Posted on Jan 24, 2009

Dan Webster

• 8220 Answers

SOURCE: Hit the clean button instead of broil - tried to cancel the

Check this out

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Instant Repair Help over the Phone

6ya.com

Save Time & Money by instantly connecting to...

Posted on Jul 06, 2010

blueextc3221

• 15935 Answers

SOURCE: Stove door locked and continues to beep and flash code F9

The F9 code indicates there is a problem with the door lock.

Try disconnecting the power to the range for 10 seconds and reconnecting. Open the oven door and hold the door switch plunger in while you try these things. Put the control into clean for 5 minutes then cancel clean. You must hold the door switch plunger in for the 5 minutes.

Try canceling the clean cycle without putting the control into clean.



Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question$$%^^%$

Posted on Oct 01, 2010