No power with new batteries minalta x-700 - Minolta X-700 35mm SLR Camera

Before you do this procedure, if the code comes back after doing this. DO NOT RESET AGAIN, the part causing the problem is the fuser (The Hot Part) it can CATCH ON FIRE that will ruin a perfectly good day. get a new Fusing unit.

1. Turn OFF the main power switch.
2. Turn main power switch ON while pressing the Utility/Counter key.
3. Touch [Trouble Reset].
4. Check to make sure that [OK] is displayed and it has been reset.
5. After turning off the main power switch, turn it on again more than 10 seconds after and check if the machine starts correctly.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

There are several options to buy replacement batteries for a Coleman rechargeable lantern, model 5348-700. I just picked up two new batteries from www.1000bulbs.com for $4.87 each plus shipping. ($20.99 for 2 with shipping!) Do a Google search for: ub645f1 6 volt - 4.5 ah - f1 terminal battery for other options

Hello,

have you tried powering the unit directly not using the powered cradle? often with the 700 series the powered cradle will break. If you can try obtaining another cradle to see if that is the issue. Also there was a recall of some of the 700 with bad batteries try inputting your serial number here to see if yours unit was one https://my.garmin.com/rma/recallLanding.faces.

Hope this helps!

You can download the drivers for your film scanner here.
http://bit.ly/dwtpvm

If you found this information helpful. please give me a big thumbs-up when you rate my answer. Thanks!

Check your brakelight wire and make sure switch is letting light go off. There is a power drain causing your battery to go dead. Also if you have any accesories make sure they don't use power when bike ignition is off. :)

try a new battery

There are a couple of them on eBay, search 'BH-70S'

Found on the internet under the heading Free download for rhe Konica Minolta model Z1 sent via PDF.
Many thanks for your efforts on my behalf as I could not find it at the time of my request.
Ahappy new year to one and all.
Ronnie

battery to plug switch is not set to except power to plug so battery can charge right now it still thinks its on the battery so no juice no comp

clean the battery terminal/connector inside the camera's battery compartment using a cotton buds with alcohol or metal cleaner