"ed25rfxfw01 Turns on and off every 1 /2 min

Sadly, you will need to replace the entire 'flapper' assembly for this machine to fix this problem. This is the part in question. 8201649 for Whirlpool side by side. However, I would suggest if you can find the entire control panel assembly (which would be MUCH easier and have less chance to break things) to do that instead.

However, clearing the shoot wont do a thing for this issue at all.

Hope this helps ya ^_^

There is a good chance that the clear shield has come out of its mount and is jamming the mechanism. Check to see if this is thae case. It is a bit tricky to get it back in but you should see a tab on the back side of the shield and it clips into a slot on the actuator arm.

Weird noise is high pitched or even grinding sound? Sounds like a fan but is not?

The black wire is from the timer motor and therefore gets attached to terminal # 1

TV has gone into "protect mode" to do just that to protect against the damaging failure that has been detected, you will need a servicer to diagnose the failure. Good luck and Merry Christmas!

tell it to go **** a fat ****

could be the lamp. It is consumer replacable.

HI, I can help you. Is the water leaking from the freezer side?

You may have the amp set to turn on via an audio signal. Set the Signal Sensing switch to OFF.

Yes, this camera has an auto power save function to save power.The camera turns off the displays and unnecessary functions if an operation is not made within a minute. (Power Save Function).To restore the power, press any button or key, or turn the exposure mode dial to another position.The length of this period is selectable from 1 min., 3 min., 5 min., or 10 min. in the section 1 of the setup menu.The LCD monitor always turns off if any operation is not made in a minute, and this period cannot be changed.If no operation is done within 30 minutes, the camera shuts itself off. Pressing the power button resumes the camera operation from this condition.