I have a dvd player that is not starting up but the standby button is flashing at two second intervals. Does the flashing indicate a fixable problem ?
Hi. In most units of this nature, you will have a stand by mode that will initiate during a major control fault that will concern the main circuit board that is housed inside your DVD players enclosure.
To confirm this control fault within the micro board, i suggest unplugging this unit for 5 minute. this is a hard reset that will drain all power and the micro board will reset itself. After the five minutes are up, simply plug back in the DVD player and power up.
If you experience the same stanby by mode and blinking code light as well after the hard reset, this will confirm the main circuit board control fault.
In this case, you will have to send to the nearest repair depot or, you can ship this device to the manufacture for a main board transplant and re-programing procedures.
Please rate and have a great day:)
Programming the 7040 OneforAll remote to enable region free playback of DVD's on the Sony BDP-S350
Quote:
1. Press DVD
2. Hold the magic button until the DVD button flashes twice.
3. Press 0533
4. Hold the magic button until the DVD button flashes twice.
5. Press 994
6. Press Magic Key (don't hold)
7. Press 1891 (this sets key 1 - the DVD button flashes twice)
8. Hold the magic button until the DVD button flashes twice.
9. Press 994
10. Press Magic Key (don't hold)
11. Press 2552 (this sets key 2 - the DVD button flashes twice)
12. Hold the magic button until the DVD button flashes twice.
13. Press 994
14. Press Magic Key (don't hold)
15. Press 0953 (this sets key 3 - the DVD button flashes twice)
16. Hold the magic button until the DVD button flashes twice.
17. Press 994
18. Press Magic Key (don't hold)
19. Press 2214 (this sets key 4 - the DVD button flashes twice)
20. Hold the magic button until the DVD button flashes twice. .
21. Press 994
22. Press Magic Key (don't hold)
23. Press 0795 (this sets key 5 - the DVD button flashes twice)
Done - the remote is now programmed and ready to use
Quote:
1. Now to make your player region free use the Sony remote that came with the player to bring it out of standby and wait while HOME is displayed
2. Make sure there isn't a disc in the machine.
3. Now on the OneforAll remote press 1, 2, 3, 4, 5 (The blue 24p light on the player will start flashing)
4. Put the player back into standby with the Sony remote
5. That's it, the next time you turn on the player it will be region free for DVD playback
If the blue 24p light doesn't flash then it hasn't worked, try a new set of batteries and start a fresh
Good luck
442 views
Usually answered in minutes!
thanks for the info, unfortunately its not economical to get these things repaired so its probably going to end up in the dump.
×