Dlinkap admin - D-Link DAP-1522 Xtreme N Duo Wireless Bridge/Access Point (DAP-1522/B) Pre-802.11n

http://support.dlink.com/emulators/wbr2310/lan.htm

Hi There

If you have not changed teh username and password, the username should be : admin and the password should be admin or just left blank.

If the username and passhave been changed, you can reset your router to the original factory settings by pressing the reset button at the back of the router and holding it in for about 10 seconds. you might have to use a thin object to get into the little hole where the reset button resides. Once reset, the username and password as above will work.

you need first to connect the router to the computer using ethernet and login using default values specified by the product on the box . such as id: admin , pass : admin

just make sure that you belong with in the same IP range.
default DAP-1360 IP is 192.168.0.50
username : admin password : <blank>
change your PC IP address to 192.168.0.xxx (e.g. 192.168.0.2)
from there you may choose wizard or manual configuration.
you may change your DAP-1360 IP add according to your network settings in the office and you must change you PC IP address with in the same range.

just make sure that you belong with in the same IP range.
default DAP-1360 IP is 192.168.0.50
username : admin password :
change your PC IP address to 192.168.0.xxx (e.g. 192.168.0.2)
from there you may choose wizard or manual configuration.
you may change your DAP-1360 IP add according to your network settings in the office and you must change you PC IP address with in the same range.

The D-Link configuration URL is
http://192.168.0.1
The default login = admin
The default PW = blank (just press enter)
To secure your wireless network from unauthorized access,please click on this link and follow my instructions :-http://www.fixya.com/support/r3559128-wireless_router_security

Hi i believe that you do have dlink access point device...
if the http://dlinkap doesn't work, try to asign STATIC IP to your computer

assign the following:
IP address:192.168.0.55
Subnet mask: 255.255.255.0
Default gateway: 192.168.0.50

the try to access again the http://dlinkap or simply typein 192.168.0.50

and thats it you're now in the login page of the access point device.

hope this will help

The DLink URL WEB configuration uses an IP address not //dlinkap
Try http://192.168.0.1
The default ligin = admin
The default PW = blank ie. nothing

You cannot configure the DLink by the URL address http://dlinkap?
You connect a LAN cable from your computer to the DLink.
Then open Internet Explorer and enter the URL http://192.168.0.1
the default login = admin
the PW is blank (just press Enter)
You can now configure the DLink.