Asko D3122 pump blocked - Siemens 24 in. SE64A630GB Built-In Dishwasher

replace the motherboard its probably damaged

Can plug in either way. If was meant only one way, the plug would have a blocking protrusion on one side. Plus the motor will run only one direction no matter which side is the hot side of the wires. As long as is getting power, it will work.

Capacitor should have a uF and voltage rating stamped on it. They are NOT a one-size-fits-all.
Always keep your Owners Manuals so you can use it to get parts. Without seeing it myself, the part will probably have to be replaced.
Sometimes you can find the manufacturer online and get parts through their website.
Possibly find this capacitor at an AC shop.

Did you ever find out what the problem was?

d3122 Asko Dishwasher fault code F2 - how do you stop pump runing and reset?

Had the same symptom; pump wouldn’t turn off, program light flashing and would stay on even if turned off, only killing the mains power would turn it off. Ended being a small split in drain hose right next to elbow under the unit.
This thread saved us from buying a new one as my wife was about to do...so thank you.

The machine has activated a safty seq. There is most likely water on the lower buttom. Leakage or drain pipe blocked. The power will get to the drain pump, when this happends. To prevent overflow on your kitchen floor. Dry out the water. Then it will start as usual.

you may have water under the dishwaher ... have any plumbing work done lately?

if the dishwaher overflows or leaks it will trip a float switch under the dishwasher... as long as it is triped it will run the drain pump.. and not let any water into the tub...

the water will have to be removed and the leak stopped before it will run a cycle....

Hope this helps if not let me know more about your problem..

Hi,

Have a look to make sure that the pump and drain hose are unblocked. If they are, you might have to call Asko and arrange a service call.

Good luck!