I have the Philips Series Pressurised Steam System, the problem is that the descal light and the water light are flashing, i have descaled it and reset it but it still keeps flashing and it doesnt work. Help!

Question edited for clarity and all the typos / spelling errors.

Descale it again, but use CLR Descaler which is made for the job. I presume you can feel heat? When using the descaler shake the unit every 5 minutes because the steam valve outlet will be at the top. of the heater chamber.

https://www.google.com/search?q=Tobi+Platinum+Model+EC1710+descale

Use the mix details for Irons and coffee machines

CLR Calcium, Lime and Rust Remover

CLR Brands https://clrbrands.com > Products > CLR-Household

Get rid of stubborn lime, calcium, and rust stains effortlessly with our powerful all-in-one cleaner. Visit CLR Brands now for sparkling, spotless surfaces.

..

If it is stuck, descale it.

Normally when water is put inside steam irons, it get stored in tank then if thermostat knob is set for steam then water moves to bottom heated portion of iron. Water converts to steam as base plate is hot, heated steam comes out through perforated holes. If holes are blocked due to scale formation steam flow is blocked. The descaling has to be done as per instructions given on descaling wax manufacturer. sometimes if water does not enter through a rubber washer that is water tank to heated bottom portion then also steam will not get generated hence no steam. Please check above points and identify the problem.

Buy a bottle of descaler and put it in the tank where you normally put the water. Put iron on hottest steam poison and run steam , topping up as required. Rinse thoroughly when finished and iron has cooled. Use distilled or demineralised water for steaming and the iron shouldn't require cleaning again.

Periodic Descaling of the iron will help reduce this.
Mineral deposits in the water will remain inside the iron after being converted to steam. This builds up over time as scales unless cleaned.

For descaling instruction, refer to manufacturer.

Hi.

The iron steam lines may be clogged with limescale.

Try first using descaling solution to clean the lines.
Do descaling several times.

If that does not work, then the thermostat may have started malfunctioning and cutting off earlier than normal. This will cause water not getting enough temperature, and iron not steaming.

Try using a descaler product, often that can fix the problem.

Fill tank with water and put steam setting to 0.Set temp pial to hottest setting. Let the iron heat up till the light in the hand goes out. Switch off power and hold iron over sink. Push down and hold descale button until all the steam and water has gone from iron. Wipe plate and heat up iron again with no water in it.

It may be cheaper to buy a new one from wallmart or similar store.

Your local grocery or hardware store will sell "descaler" for coffee pots and irons.

Mix as instructed (water/descaler) and pour the disolved mix into the iron. Set the iron on the highest steam settings (heat and steam volume). After it is hot, let it steam into the sink, pressing the steam button over and over to let the descaler work through all the tubes/passages, until it has all been pumped out.

Refill with more descaler (if it is not completely unplugged) and repeat until you are satisifed with how the iron is working.

After descaling, run clean water through it with the same process (but no descaler) several times.

Place the iron soleplate, unplugged of course, in a shallow dish of water and descaler and leave it for a while. I have just done this with mine and its working a treat.