My husqvarna yth2448 blade keeps stopping. Can I make simple adjustments, or do I need to change belts, or something else?

YTH2448 HUSQVARNA TRACTOR Manual

Searching Model For Search Your Way yth2448 2

Your deck belt adjusted or maybe a spring or etc. come off.

I had one, the deck belt routing diagram was not only in the manual, it was also on a little decal attached to the top of the deck. A google search goes a long way, check for AYP and MTD websites as they make about all the mowers, regardless of the label on them.

check the belt as it bound, if you do not think so then take it off(the belt) and engage the PTO if it does not die then it is: the belt, pulley, or blades are/is the reason why it is stalling Tim

Could be something jamming a blade or belt. With the engine OFF and the key OUT make sure the blades and belts all move freely by hand. Clear out all grass and c**p from the blade and belt areas. You may have to remove the blade deck to do this - instructions are in your manual or download a manual from the Husqvarna website. Good Luck!

I have a husqvarna yth2448 mower whitch the pto switch burns out and pull apart .Blade stop turning and mower remains running

It sounds like your charge system is not working. If you jump the battery the engine will run with a weak battery but the pto clutch needs a strong battery to stay engaged.Try this to test it,after you jump it leav the jumper cables hooked up and try to engage the blade clutch,if it runs it is either a battery that wont take a charge or a charge system not working. If you put a volt meter on the battery while the engine is running and the voltage is 13 volts the charge system is working and the battery is bad.

Make sure the mower rake angle is not too much,On level floor point one of the blades in a front rear orientation,measure height of blade from floor the front measurement should be no more than 1/4" lower than the rear measurement.If the front of the mower is too low the angle the belt has to run is too much and the belt will twist and wear rap[idly.To raise the front of the deck there are either one or two adjustment rods that attach the front of mower deck to frame tighten this adjustment up to raise the front of mower deck.

you probably need to adjust the tension. if you look somwhere near the drive belt then you see a spring. tighten the spring to tighten the belt.