The above mentioned model is 3 years old, worded fine so far but stopped in mid cycle without any error codes showing. Turned it off and on again but only a double beep appears, nothing else. Tried other washing cycles, same result. Filter is clean, door shuts correctly (no 'connection' problem here). Water still in the bottom of machine, doesn't pump it out, doesn't start, nothing. Any ideas out there, please?
Since water doesn't drain out ,it could be a clogged in the drain line. Often the problem is at the point where the drain line attaches to the garbage disposer or household drain line. You should remove this line and clear it form any debris in the hose or the hose connection. Be sure to reattach the hose before starting the dishwasher again. Good luck!
The solution by Dovi was correct. Cleaned the filters and all debris at the bottom and took the left hand side off and cleaned stuff out of the top of the plastic water/air part. It still did not work, but the pdf file that we downloaded suggested that if the motor had been overloaded then the safety cutout then needed to reset itself. We were disapppointed that this didn't happen immediately but when we tried some 5 or 6 hours later it worked. Saved ourselves $$$$ this time on a plumber's bill!
try it . push it up from on side , left or right , a little bit water will go out and all the problem disapear....
×
according to the manual that i have just downloaded from the net,E1 code means.water leakage in Hose connections.
.water is leaked by damages
hope this helps,
keith
3,002 views
Usually answered in minutes!
Same here. With the addition that LEDs are failing on the display. Went to debug mode with Normal-Eco-Power. First press of go/pause button registers a high/low (5 times?) tone and subsequent presses the double chime. IE not the expected diagnostics
Hence I suspect PCB failure?
Stopped working mid cycle, display went black and lost power. Turned off power, checked fuses and changed power point cannot find any fault.
drain pump working, no water in bottom of machine but displays error 20 with double beeps repeating.
×