I need a free manual for a shopsmith mark v - Saws

Possibly similar parts manual:

https://www.shopsmith.com/service/scroll_saw/scroll_saw_parts_list.htm

Shopsmith Scroll Saw Service Parts List

If you want to know drill press attachments open the link Best Drill Press 2018 Top 10 Drill Press

The Shopsmith website has instructions here: http://www.shopsmith.com/ownersite/servicetips/oilingmarkv.htm .
There is a great set of photos that show all the steps located here: http://www.songofthegreatlakes.com/sslube.htm

for more info please see the owners manual here: http://www.shopsmith.com/ownersite/manuals/845539.pdf and view page 31 -32

1. Slide the new blade into position, working it up through the table slot, around the guard, and onto the wheels, as seen in Fig. B-26. The teeth must be pointing down and toward the front of the Bandsaw (and toward you). Position the blade approximately in the center of the rubber tires and in between the guide blocks.
2. Check the tension scale alignment. With the blade slack on the wheels, the red indicator bar should be parallel to the left edge of the tension scale. If this is not the case, follow the alignment procedure described in Alignment section. Fig. B-26 Fig. B-27
3. Tension the blade, turning the blade tensioning screw clockwise, as demonstrated in Fig. B-27. Notice that as you turn this screw, the red indicator bar moves, because it is actually the flat spring that tensions the blade. The blade tension is properly set when the edge of the bar disappears behind the scale at the marking for the blade width you're using. On a few operations, such as sawing thick stock with a thin blade, it may be necessary to increase the blade tension slightly beyond the normal setting. However, this increased tension will shorten the life of your blade. Always remember to reset the tension screw when you no longer need extra tension
4. After you've spun the blade several times by hand, it should be centered on the three roller bearings, indicated in Figs. B-29 and B-30. The back of the blade should rest against the auto-track roller bearing and the lower blade guide roller bearing, and it should be no more than 1/64" away from the upper blade guide roller bearing. If the blade is not properly positioned on the bearings, follow the procedure described in "Adjusting Roller Bearings" in the Alignment section.
   

iFixit: The Free Repair Manual

https://www.ifixit.com/

iFixitiFixit is a global community of people helping each other repair things. Let's fix the world, one device ... We stopped by the European Parliament in Brussels to show some folks there how to fix their phones. The repair-focused ... Fix the Planet.

Shopsmith Repair Manual Planer - womensvictoryopen.com

dull69.womensvictoryopen.com/shopsmith-repair-manual-planer-xuvjjqe.pdf
Shopsmith Repair Manual Planer. Shopsmith jointer manual - free eBooks download. Shopsmith jointer manual download on apexjournals-3.org free books and ...

google the question, possibly youtube, or owner's manual from
manualslib.com

Hi,
The Mark V?
Download the manuals from the link below.

www.shopsmith.com/ownersite/productmanuals.htm

Ken.

They make special vises for drill presses. once attached your surface is adjustibal from 0 to 90 dergees. Spme accessories you atach to the plate will allow x and y movement by turning the handle so if you get both there is no angle you can't work...just like a machinest.

Are you looking for a Shopsmith Owner's Manual? I have from 15 years ago.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jay_17408fb1a2cad107

You can find it at http://www.owwm.com/MfgIndex/pubdetail.aspx?id=2694 download it and print it.