Dlink password - Belkin N1 Vision Router

change the password with a new one (not the default), then change the ssid with a new one (not the default). then reconnect

You need to log into the dlink router and look at the Wireless Security and you will see the password. To get into the router you will need the ip address of the router, the default user id and the password. You manual will give you this info if you do not know it.

Get online and got to www.google.com In the google search box type: "Dlink Support" (without the quotes and put your manufacturer name before Support). Look for downloads and drivers. Enter your model number and operating system when requested. Look for Manuals.

The IP address to put in your browser to get into the router is: 192.168.0.1

The default userid is: admin

There is not default password, so leave it blank.

the default dlink password is password or 1234
if that doesn't work then the password has been changed and you will need to reset the router to factory defaults. hold the reset button for 30 seconds while powered on.

access the router by typing its default IP address on your URL browser.
IP Address depends on router brand:
LinkSys 192.168.1.1
DLink 192.168.0.1

username and password for Linksys is admin
Dlink has admin username but no password

then browse the administration page to setup password

You can download the manual from this WEB site.
ftp://files.dlink.com.au/products/DSL-G604T/REV_A/QuickInstallGuide/DSL-G604T_QIG_v1.00.pdf
Page 8 gives you instruction on changing the password.

Use an Ethernet cable to connect the laptop to the router.
Access the router's built-in web-interface, and run the "Wireless Networking Setup Wizard", and choose a password.

just open your dlink ip page and type the username as admin and leave the part of password.

it will open a page where there is a palce to add a wifi password



sagar

Need to know if it is wireless password or GUI password?

Type 192.168.0.1 (you can type the router address if you have changed) and enter on browser's addressbar. Router's interface will appear.
Click on SETUP and Click on the WIRELESS SETTINGS at left side. on the page you will see the option of WIRELESS SECURITY by drop down menu you can choose the Security mode that you wish. here is the link for the emulator
http://support.dlink.com/emulators/wbr1310_revB/wireless.htm

Please post your question if you need further assistance
Good Luck