Jura Capress Impressa E8

Operating Manuals - Jura Capresso Coffee Machines

capresso.125west.com/html/operating_manuals.html
Operating Manual Impressa F9 and F9 Limited Edition. Operating Manual Impressa F7. Operating Manual Impressa E8. Capresso C1300 Superautomatic ...

Hi Jill our coffee machine is built in and not your brand but our problem related to a sensor at the back of our tray which had broken off we found it and glued it back on which worked for a little while in the end we replaced the tray and have had no further problems. Hope this help. Cheers Wayne

For Jura F7 Series, "Tray Missing, can't put it back in". With a small flashlight, look in to the cavity which the tray and grounds container reside in. Along the right side above a slot to the end, you'll see a white micro switch. with a "Tooth Pick" simply press the switch inward (to the right) and hold till the machine cycles the Levcer / Flap up and out of the way.! Put your tray and grounds container back in and begin brewing!! -dh

I had the same issue. Had to send it to Jura to be repaired. Cost $235.00 and they cleaned it and sent it back. I was not able to fix it myself. They said there was a major blockage.

pls try to clean your the cleaning censor maybe it has a dirt attached thats why it says the machine or maybe the censor is deffective.

I have the same machine and this seems to happen if the grounds bin is pulled out before it goes through a full cycle. take both the grounds and water trays out. Try to fit the grounds bin around the "elevator", slide the grounds tray underneath that then the water tray as well. It should slide right in then the machine will complete the cycle and work just fine :)

These are available online if you search Jura Capresso . Foe E8 I suggest you call the Jura Service line at 1-800-220-5701 - they are fantastic at helping out

Simple fix - got the machine serviced, needed a new thermoblock apparently, could also have been one of the couple of sensors they replaced. Total cost including box, bits and carriage - £180 plus change.
Expensive but now I have it back, it all seems worth it!

You can find some detail procedure in this tip below
http://www.fixya.com/support/r5713182-jura_capresso_impressa_f9_malfunction_8
Try it since it have help some other with same problem.

I had this problem and I solved it by letting the machine dry out overnight. Before I turned it back on I removed the drawer and wiped the area inside the internal flap then I used the pressurized air that you use to clean a computer and blew out all of the residue. It has worked well since then.