Pyromaster electric fire place motor for flickering flame

Question edited for clarity and add a maker.

$143 in this link. The first motor is for the flame effect. It is the one that comes with the fan.

https://www.fireplaceparts.com/hef33-serial-efah2i0-pyromaster-electric-fireplace.html

Also on Amazon

https://www.google.com/search?q=pyromaster+hef33+replacement+parts

..

Question edited for a lot more clarity.
Question moved from Televisions category.

Try the maker CFM Harris System Inc

https://www.manualslib.com/manual/627061/Pyromaster-Hef33.html#manual

Or places that do spares.

https://www.google.com/search?q=hef+33+electric+fireplace.+power+cord+replacemen

If not, it is just a heavy duty power cord with a molded plug that you can get from Home Depot. It must be good for 1,500 watts.

This is what the old one was like

https://www.justfireplaceparts.com/monessen-10003095-cord-power-16-3-hpn-w-terminal.html

You could get this one and cut the socket off the end, good for 1,850 watts.

https://www.amazon.com/POWTECH-Conditioner-Appliance-Extension-3-PRONGED/dp/B009DG1QR8/ref=sr_1_2?keywords=space%2Bheater%2Bextension%2Bcord&qid=1681363930&sr=8-2&th=1

..

Hello, Susan -

You have not stated the model number of your Pyromaster electric fireplace, therefore it is a challenge to locate the exact replacement knob you need.

Perhaps you will find your model listed here:
https://www.ibuyfireplaceparts.com/pyromaster.html

Best wishes.

Flickering flame fires generally use a fairly ordinary tungsten filament incandescent bulb, except the Fireglow bulbs are coated with an amber coloured lacquer. The heat from the bulb causes an upward current of air causing a small "windmill" to turn and cause the light to flicker.
That is the traditional method but ultra modern fires might use a higher-tech solution.

If you're not getting any flame effect or only a portion of it. One or more of the 60 watt small base chandelier bulbs is burned out. Replacing one or more should solve your problem.

here is a picture of it. It took me about 4 minutes to put the new one in.

http://www.ibuyfireplaceparts.com/monessen/10001978-motor-variable-speed-12v-dc.html

I have the same model and problem there must be some part to get to replace it it seems to be a motor problem. would appreciate any ideas

You will have to connect a 12v dc power supply to the flame motor. The controller on the board has fried. I built a regulated 12 v dc power supply and tapped it into the bulb circuit so it will power the motor when the bulbs come on. You may have to find an electrician or techie to rig this up safely.Good luck!

Yes, there is a reset button. I have the same problem but the reset button doesn't do anything. I do have power but the flame does not come on.

basically, on the bottom of the fireplace, there are 2 screws on the sides, 3 on the back, take them off, lift bottom (it wont come off, so be careful not to bend it) there are 3 christmas light type bulbs, you can find them at any hardware store. Just replace them. Problem solved.

If the flame is standing still, i assume the motor is burnt out. or the belt is off.